Your cart is empty.
Your cart is empty.Joe
Reviewed in the United States on February 28, 2025
These are Meah! Cheap red junk but they work, I certainly would not use this in anything that you plan to use for years diwn the road as I’m pretty sure they’re going to corrode and they are flimsy and not a quality part, but they will get the job done in a pinch and they’re cheap enough, but you know the saying you get what you pay for.
LenG
Reviewed in the United States on January 5, 2025
Work well and you can put them together to form as long as you line as you want.
Stephen F.
Reviewed in the United States on January 23, 2025
hydro line bit doesnt actually thread in, pulls out with little force. only one side is magnetic, that is not conducive to a lot of situations. you cant actually pull them through with the bits on due to the size of the bits so you pull it through without it. no big deal right? wrong, it unthreads itself due to this because you have to twist it on after routing due to the one sided magnet. just get the park tool
C. Pehl
Reviewed in the United States on September 23, 2024
I'm impressed. I have used brand name terminal blocks and when you Be aware that the opening is pretty small, you need to back the screw all the way out in order to get a tightly twisted 18ga wire into them. 18GA is the absolute max that will fit and it's tight. But the screw press thingie holds tight and you can clamp down pretty hard for such little things. These fit 2.54 pitch perfectly. The legs accept solder nicely. At first I thought "why did they include this crappy little screwdriver? Let me say "I'm glad they did". My only wish would be for them to use a plastic case that the screwdriver fits inside.
Brian Curtis
Reviewed in the United States on August 4, 2024
These screw terminals work great on breadboards and prototype PCBs with the correct pin pitch. The through hole pins take solder just fine as well. No complaints here.
T
Reviewed in the United States on June 3, 2024
I do a lot of DIY electronics. I'm used to using 5mm terminal blocks, never really considered using 2.5mm. These are great for standard breadboards because they take up half us much space. 5mm blocks waste a lot of space on breadboards/protoboards. These carry an audio signal to my 3w speakers just fine which is all I need. The screws are a lot smaller, but it comes with a small screwdriver if needed.
Sly
Reviewed in the United States on December 18, 2024
These work perfectly with my pc boards and the addition of the screwdriver is great.
Recommended Products
$56.99
$ 25 .99 $25.99