Your cart is empty.
Your cart is empty.Dynatex silicone adhesive/sealant is a paste-like, one-component material, which cures to a tough, rubbery solid upon exposure to moisture in the air. Provides transparent, watertight silicone rubber seal for a wide range of applications. Seals, insulates and bonds. Works well on marine, recreational and industrial applications. Bonds and seals. Waterproof and weatherproof seal. Insulates thermally and electrically. Permanently flexible. Applications: windshields, sunroofs, tail-lights, interior panels, firewalls, dashboards and more. Bonds and seals: auto and appliance trim, including metal, fabric and fabric backed plastics, glass, vinyl, wood and rubber, trailers, truck cabs and frayed wires. Dynatex silicone adhesive/sealant has good resistance to weathering, vibration, moisture, ozone and extreme temperatures. It may be applied in sub-zero weather without loss of extrusion or physical property characteristics and is effective to -35 degree C(-30 degree F). Fully cured Dynatex silicone adhesive/sealant can be used for temperatures up to 450 degree F. Type: one-part silicone rubber. Physical form: non-slumping paste. Cure: cures at room temperature on exposure to water vapor in the air, giving off a small amount of acetic acid. Special properties: meets or exceeds oem volatility specifications. Won’t foul engine sensors. Primary uses: general purpose sealing and bonding as a space-filling rubber adhesive. Specific gravity at 25 degree C (77 degree F): 1.02. Extrusion rate: (3.18 mm orifice, 90 psi air pressure), g/min: 400. Flow rate: (sag or slump on 3.18 x 101.6-mm bead), mm: nil. Tack-free time at 25 degree C (77 degree F) and 50 percent RH, minutes: 10 to 20. Cure time at 25 degree C (77 degree F) and 50 percent RH (3.18-mm thickness), hours: 24 . Container size: 3 oz tube. Clear color.
Lightworker
Reviewed in the United States on February 27, 2018
Good adhesive for LED strip lights.
PJB
Reviewed in the United States on October 7, 2018
So smelly
Kindle Customer
Reviewed in the United States on April 9, 2018
The goop is thick and works well as an adhesive. As a sealer, though, it is difficult to apply because the tube it comes in is flimsy and burst at the crimp in the bottom.
Night Dove
Reviewed in the United States on September 24, 2016
Durable, More tacky than permatex. Harder to spread into grooves. Not bad.Just a bit too thck.
archgreen
Reviewed in the United States on February 21, 2016
Half the tube was hard or hardening when I received it. Only needed a small amount to seal BBQ draft door however. As I strongly squeezed the tube the bottom blew out. I did mine enough to finish the job at hand.
not replying for reviews
Reviewed in the United States on April 27, 2016
handy small tube of silicone used for sealing led tail lights.
Recommended Products
