Your cart is empty.
Your cart is empty.Product Description
Please don't peel off the protective paper to avoid cracking while processing.
Howard
Reviewed in the United States on February 15, 2025
Perfect. Thickness is correct for a frame. The plexiglass was protected with a film on both sides AND then wrapped in a protective bag.
Citi Aadvantage
Reviewed in the United States on February 13, 2025
No more braking glass and this product is very strong and clear.
Don K.
Reviewed in the United States on January 29, 2025
Item is perfect for protecting top of dresser or table. was a bit thicker than I expected but still does the job. Can clearly see through to pressed photos or maps while protecting them at the same time from occasional water over flow from planters on surface. Order was delivered in a box that was way too large. So It arrived looking all beat up and taped together with clear packing tape. Fortunately the product was not damaged. This is unusual for AMAZON orders. Otherwise, all is good.
Vega
Reviewed in the United States on January 19, 2025
This is exactly what I needed to put on some stickers to display. It's manageable, and not heavy, as glass would be.
seabasket
Reviewed in the United States on January 16, 2025
These hold my large (9x12) gel plates perfectly! Just thick enough to not bend or warp. I sanded the edges/corners before use.
Virgil R. Baker
Reviewed in the United States on December 11, 2024
I used this to replace the plexiglass in our bird feeder. It is a lot better quality than others I have used. It cut very nicely without splintering or cracking like others in the past.
Donna L.
Reviewed in the United States on December 10, 2024
Worked perfect for my project. Liked the fact that both sides were protected with a layer if film.
Chuck
Reviewed in the United States on December 10, 2023
It's pretty thin, and it's acrylic. What that means is that if you try to use it as an aquarium lid, it will sag.Ordered 2 pieces and I got it at about 10 bucks/piece. The dimensions are quite large, an appropriate size for a 10gal fish tank lid when cut down. However, it sags quite badly. I should have sprung for a sheet that was polycarbonate and maybe 1/4" thick, which is a decent bit pricier but has much less of a chance of sagging.Use the right material for a project. This would probably work fine for a picture frame cover, or something along those lines. If it's vertical and supported on all edges, it probably won't warp or sag much.
Recommended Products