Your cart is empty.
Your cart is empty.3.6 out of 5 stars
- #368,614 in Industrial & Scientific (See Top 100 in Industrial & Scientific)
- #32 in Pulse Generators
Note:
The high-voltage module should avoid the use of electricity in high voltage no-load . (Power must be adjusted to a suitable distance to the high-voltage output line , battery capacity is proportional to the distance and the use of the high-pressure arc ( not a voltage as high as possible , you must provide enough current ) .
Experimental test of the arc distance from short to long , Do not exceed the maximum arc distance electricity, energy can not be released due to high pressure , can easily damage the module. )
Work: intermittent , continuous work does not allow more than 1 minute and the output side does not allow shorting . Improper voltage and long working hours easily damaged module.
Product description
Size：24x22x63mm
Input voltage: DC 3V to 6V
Input current: 2A - 5A
High pressure type: the type of pulse current
Output voltage: 400000V(Please pay attention to safety)
High pressure discharge distance between: 10mm - 20mm
The output high voltage wire length: 100mm
Input power cord length: 100mm (the red line is positive)
Nick
Reviewed in Canada on March 3, 2025
Units fail nearly immediately with spaced gap even at low under 6 volt . Hassle if being used and installed. I have another set the 800-1000kv that work well and reliably . Look elsewhere
Jeanette Aviles Aquino
Reviewed in the United States on July 28, 2024
Si le pones una batteria de 9v y lo tocas te tumba el brazo, te arrepentiras
Thorr
Reviewed in Canada on November 28, 2024
i use them as ignitors for my rocket engine. they ignite a mix or propane and air at great flows.
stewart Thorpe
Reviewed in the United States on September 29, 2022
Good price, high quality, good shipping time.
Ron
Reviewed in the United States on June 8, 2022
The media could not be loaded.
Blake C.
Reviewed in the United States on March 31, 2022
Very easy to utilize.
Purchaser
Reviewed in the United States on March 19, 2022
2 of the three worked at 8 volts ok, but very very hot with even short run time. At 12 volts, one melted the plastic case in 5 seconds. The third didn't work at all. All of the above at 10mm arc length. Junk in this batch. lets see what the replacements do....
Recommended Products
