Your cart is empty.
Your cart is empty.3D Printer Black Smooth PEI Textured PEI Bambu Labs Build Plate for Bambu Labs X1 X1C X1E P1P P1S A1, PEI Spring Steel Sheet Plate Flexible Platform 257x257mm for Bambu Lab 3D Printers
Truitt Wilson
Reviewed in the United States on February 16, 2025
First print came out looking great, the plate not so much. I went to print again and the bubbles caused issues on my next print. Unacceptable honestly.
Brad
Reviewed in the United States on January 3, 2025
-Be very careful when taking the plate in and out! The small tab at the top of the plate, where the printer cleans the nozzle, is sharp enough to scratch the bed. If you drag or push it with the tabtouching the bed it will scratch. I really wish they would of put a warning somewhere. Make sure to pick the plate up completely before moving.- As many others have already stated the plate has to be very clean. I cleaned it with warm water and mild soap. After installtion I used isopropyl alcohol on a paper towel, wiping inmultiple directions to do a final clean before printing.-Most PLA will stick after increase the bed temp to 60C. Some PETG will stick after increasing the bed to 80C.-Slow down the first layers. I'm printing the first layers at 30mm/s.-The most important question is would buy it again. The answer is probably..This is my first effect plate and thefinish that it gives is absolutely incredible! If you haven't tried one yet I absolutely recommend trying one. The final result from this plate is great, but you do need to be careful.
Eliana
Reviewed in the United States on January 15, 2025
The designs are beautiful. Adhesion is next to none though. But if you spray it with hair spray it helps tremendously. I recommend the plain aquanet. Remember to clean it off before reapplying the hairspray. Otherwise it will effect the texture transfer and you’ll see where your last print was.
3Deitz
Reviewed in the United States on January 10, 2025
The media could not be loaded.
Tikki
Reviewed in the United States on August 21, 2024
This plate was better than the one I got from Bambu labs for the same price. Came fast and was a sturdy plate. The one I got from the maker was as thick as a sticker and flimsy.
Brody
Reviewed in the United States on July 14, 2024
I’ve had this plate for a few months now, and it works amazing. It has great print adhesion and is easy to remove. It fits just like the official Bambu plates and is easy to put in and take out. It also really helps to make the bottom of the print look nice and smooth, and gives it a great pattern, although you do have to shine light on it to see it.
JC
Reviewed in the United States on February 9, 2024
Textured PEI side works like a charm - and the opposite side has some kind of holographic confetti looking effect, which can be seen on the bottom side of your finished print (shows better on larger prints). I only do PLA and both sides worked without issue. Great adhesion, and easy to bend and pop off your completed prints.
Jacqueline
Reviewed in the United States on December 22, 2024
The media could not be loaded.
Recommended Products
