Your cart is empty.
Your cart is empty. Product Specification
Threaded wood insert nuts feature threaded designs, external protrusions bite into the wood, providing superior holding power and preventing the insert nuts from either turning or pulling out in all applications.
Material: High Quality Carbon Steel
Exterior Finish: Zinc
Internal Thread Size: 3/8"-16
External Diameter: 15.35mm
Total Length: 25mm
Package Included
15 x Threaded Inserts for Wood 3/8"-16 x 25mm
1 x Hex Spanner
Warranty
MewuDecor hardware has the highest quality on the market. Buy with confidence. Money back or exchange guarranteed.
Yuba
Reviewed in the United States on February 5, 2025
They work great. Two tips. (1) Cut the hex key so that you can slip one end into a drill for faster installation. (2) Coat the threads with epoxy to prevent any potential loosening.
David L.
Reviewed in the United States on January 28, 2025
Exactly as expected. Quality product
Tom
Reviewed in the United States on September 1, 2024
These inserts work fine, but, yor may have to ream the insert hole before inserting them in end grain of 3/4th inch hardwood to prevent splitting.
William M.
Reviewed in the United States on December 9, 2024
These are a good product. I searched Home Depot for something similar and they had nothing that I found. I used these to mount a small table saw and a table vise to my new rolling workbench that has 3/4" butcher block top. The inserts were easy to installed and screwed in perfect and look really nice. Now if I remove that equipment from the workbench I will be happy with the holes I put in the block top because they look great on their own.
Tommy B.
Reviewed in the United States on December 6, 2024
I used these to attach a tabletop on a coffee table and they worked flawlessly. Will certainly buy other sizes from this company when needed.
Kelsey
Reviewed in the United States on November 5, 2024
These have held up well. We used them to attach a table top and legs. They were easy to install, none of them stripped out, and they work as we had hoped.
Paul Gebhardtsbauer
Reviewed in the United States on November 27, 2024
Like: fit and finish are great. Can be installed with a hex key or a 5/16-18 bolt. If drilling completely through a board, it can be installed from the back to eliminate collar visibility. You can also use a 1/2” forstner bit to countersink the collar and set the insert flush with the adjacent surface.Dislike: no information included. Trial and error required to determine required drill bit sizes. For 5/16” insert, use a 7/16” drill bit. Vacuum the hole before insertion or the bottom of the hole might blow out from compacted sawdust.
Ol timer DM.
Reviewed in the United States on November 22, 2024
I installed in pressure treated 2x4 , pre drilled with 1/2” brad point drill bit using a 90deg.guide fastner went in firmly ( no instructions or suggestions provided by supplier) worked very well. Reasonably priced.
Recommended Products
