Your cart is empty.
Your cart is empty.Product Description
Style 2 - 2Pcs
2Pcs Ignition Coil Connector Pigtail Harness CU2Z-14S411-AFA with Heat Shrink Connector
Part Number: CU2Z-14S411-AFA,CU2Z14S411AFA
TD
Reviewed in the United States on February 6, 2025
Fit perfectly and finally got rid of the pesky misfire. Curse you squirrels 🐿️
Dallan
Reviewed in the United States on February 2, 2025
Good luck finding the right piece. I had to go to the dealer, and they didn’t get it right either.
Zachary Berry
Reviewed in the United States on January 13, 2025
Do not buy these. I ordered 4 of these and every single one of them broke. Two were already broken when I got them. The red tab broke when the locking lever was engaged and jammed in the connector.If you buy these you will waste your time and money.
FatZac
Reviewed in the United States on September 24, 2024
Depinned so I didn’t have to splice wires. Works great.
Lionel Chabot
Reviewed in Canada on May 25, 2024
I was after the parts themselves as I didn’t want to add in pigtails to my coils. Took old one apart, pushed wires out, stuck wires into this connector and I was done
Ray
Reviewed in the United States on December 9, 2024
Fit my cars coil pack and was super easy to do plus was cheap probably saved me 100s. Granted I didn’t have to do any wiring just the connector. Sturdy cause didn’t break and I was ignorant and rough
James Collins
Reviewed in the United States on November 14, 2024
Just like factory. Great
PAG9195
Reviewed in the United States on October 2, 2024
Worked great to replace a connector with a broken tab. I backed out the pins, installed the new connector onto factory pins, and voila! Nice new connector instead of 3 zipties holding a broken connector together.
Customer
Reviewed in the United States on April 7, 2024
Purchased due me breaking one of my stock connectors on a 2015 Ford F150 3.5L Ecoboost.As recommended by another reviewer I planned on depinning it and using the connector only versus splicing it into the truck wires. However when I tried to depin the connector (with special depin tools on Amazon) I could not get them to ‘unlatch’. Ultimately I ended up carefully taking apart the connector by taking off the white front piece (using two micro screw drivers and a third one to pry) which then allowed me better access to ‘unlock’ each wire. Did the same thing on my truck and slid this connector on and wires into place then the white piece and locked everything in place.Just a word of caution: Testing the red slider it did get caught on the grey ‘latch’ which it locks in place and broke one of the red tabs pushing too hard. I removed the red latch on the other one and carefully bent it slightly up so it didn’t happen again.5 stars because the connector is a direct replacement of the stock connector and worked.
Recommended Products
$30.56
$ 13 .99 $13.99