Your cart is empty.
Your cart is empty. The ADXL345 is a small, thin, ultralow power, 3-axis accelerometer with high resolution (13-bit) measurement at up to ±16 g.
Digital output data is formatted as 16-bit twos complement and is accessible through either a SPI (3- or 4-wire) or I2C digital interface.
Supply voltage range: 3V to 5V
Digital-output triple-axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g and integrated 16-bit ADCs
Accelerometer normal operating current: 450µA
Ultralow power: as low as 23 μA in measurement mode and 0.1 μA in standby mode at VS = 2.5 V (typical)
Sleep mode current: 8µA
Communication: SPI (3- and 4-wire) and I2C digital interfaces
Package inlcuded:
2 X GY-291 ADXL345 3-axis digital acceleration module
2 X 8P pin header
Sleewok
Reviewed in the United States on September 11, 2023
Wired up following klipper docs after locating the pin out for my pz2w. Worked perfectly. I tested both modules.
JVZ
Reviewed in the United States on September 10, 2023
Was trying to pair it up with a Seeed Studio XIAO RP2040 (that I bought the same day at Amazon) to configure input shaper on my 3d printer. The first adxl345 was DOA. The second one initially worked, was able to get readings in the console. Then, after a minute or so, smoke. RP2040 was fried, literally. Hopefully the USB on my host was not damaged. Was a waste of about 20 dollars. Do NOT recommend
phoenix_jmed
Reviewed in the United States on August 30, 2023
works well
smp
Reviewed in the United States on June 15, 2023
used to run input shaper on ender 3 with raspberry pi zero.
Daniel D
Reviewed in the United States on November 4, 2023
Only one worked.
Greg and Renee
Reviewed in the United States on August 7, 2022
Bought this with the intent of setting up Klipper's input shaper on my core xy 3d printer. The first chip I tried was dead on arrival, but the second worked perfectly. Im happy enough since I only needed one, but maybe be cautious if you need two chips.The chips arrived in a small padded mailer, each chip was individually wrapped in an anti static bag with a 6 pin GPIO male header inside.
Michael
Reviewed in the United States on June 2, 2022
No problems, they work as described.
Charles S.
Reviewed in the United States on May 5, 2022
I found multiple wiring diagrams to connect this to an RPi for klipper input shaping and I ended up having to desolder and resolder but in the end, this worked flawlessly.
Recommended Products
$38.00
$ 19 .99 $19.99