Your cart is empty.
Your cart is empty. Packing list:
2 * Diameter 8mm Length 150mm Linear Motion Rod
MCoupland
Reviewed in the United States on July 10, 2024
2 long metal cylinders. Not much more to say.
arturo laines
Reviewed in the United States on May 19, 2024
Precise size for my project. Used it as clamping surface of a mini mill table so I could square up the ends with a larger mill
john covin
Reviewed in the United States on May 12, 2024
While I have not used this item yet, it is exactly what I needed.
Mrs. A
Reviewed in the United States on March 17, 2024
Precision machined and looks great!
Adam
Reviewed in the United States on November 10, 2024
Looks great, used these for an art piece. Perfect description!
Sid Bitters
Reviewed in Canada on April 21, 2024
In can’t comment on wear but they fit perfectly in the x-axis of my purse 2.5s.
jody trobaugh
Reviewed in the United States on August 16, 2023
I didn't use these for robotics, CNC, or 3D printing, but they were absolutely perfect for the project they were purchased for. I didn't spend much time on any measurements, but they were consistent enough for what I was doing. I wouldn't hesitate to buy them again.
Shadow
Reviewed in the United States on July 10, 2023
They were about 5mm too short for the bed of my Robo R1+ but I was able to make some spacers to deal with the problem. Nice quality other than that small problem.
Coko
Reviewed in Spain on April 22, 2023
Buena calidad
StanSPP
Reviewed in the United Kingdom on March 2, 2022
I got two sets of these (Y (330mm) and Z (320mm) axis) for an LDO Bear2.1 upgrade for my 3d printer. Well packaged so they arrived in perfect condition. Accurate lengths and my standard bearing run nice and smooth with minimal noise.
Mark B
Reviewed in the United States on September 20, 2019
I have tested several rods using a dial indicator to check for straightness. I use the HF digital dial indicator on a magnetic stand. The key to getting consistent results is to have a follower that rides on top of the rod so that minor xy position error does not affect the dial indicator reading. I use a piece of glass as it provides a perfectly flat surface to the rod. Good stock rods are typically
Bernd Sander
Reviewed in Germany on November 27, 2019
Die Originalwellen sind ein graus und nach dem Austausch mit neuen Lagern läuft die Y Achse besser
MikeL
Reviewed in France on April 14, 2019
Acheté en remplacement pour mon imprimante 3D, elles sont parfaitement linéaires(ce qui est rare), la rigidité est excellente et le traitement de cémentation est de très bonne qualité.
Recommended Products
