Your cart is empty.
Your cart is empty. Features:
1.This front bumper lip support rod is used to reinforce car front splitter.
2.Articulated top and bottom joints, which allows you to install at any angle.
3.Installation require drilling holes into the bumper lip diffuser to attach safely to the vehicle.
4.Made of aluminum alloy and carbon pipe, you don't have to worry about the quality.
5.Compatible with most of cars.
Size:
Rod Length: 45mm/1.77"
Total Length: 140mm/5.51"
Package Included:
2 x Car Bumper Tie Rods
Julisa Hermosillo
Reviewed in the United States on November 12, 2024
Works great and is easy to install! I've always used the rubber gasket looking fender holder, but would need to replace every few months or so due to it drying out and ripping. This is firm and looks good!
Yanny
Reviewed in the United States on April 2, 2024
Excelente
Marc A.
Reviewed in the United States on June 26, 2023
I just installed these on my car and they were not hard to do, so far I haven't had a problem but I just got done and now it's time to drive and see if they will loosen or not. I do like them though and now I need a longer pair for the middle of the splitter.
Harman
Reviewed in the United States on January 14, 2023
Waste of money
Recommended Products
$55.24
$ 23 .99 $23.99
$149.95
$ 73 .99 $73.99