Your cart is empty.
Your cart is empty.Product Description
3Pieces-2.5inches(65mm) Imapct Magnetic Bit holder
Made of Cr-V Steel quick connect drill bit holder
Absorbs torque peaks to reduce breakage and comes with high-visibility sleeves for greater user convenience
The magnet is located inside the tube which securely holds the bits in place
This extension bit shaft is very straight, it almost has no wobbling when you use it with impact screwdriver
peyman
Reviewed in the United States on February 22, 2025
Not good quality
John R
Reviewed in the United States on January 20, 2025
They do NOT lock in your bits. Tp they can be pulled right out. I tossed them in the trash, I'm far to busy with work to even return them.
Customer
Reviewed in the United States on December 12, 2024
So far I have enjoyed using these bit holders. I have bought tons of them over the years. They seem better made than some of the big name brand ones I’ve used that have broken.
Uncle Jack
Reviewed in the United States on November 19, 2024
It's always great to have extra extensions available and this is a nice one. I love how it's not just magnetic, it actually hooks onto the bits. I will be using this a lot.
William Collins
Reviewed in the United States on October 28, 2024
Helped to install screws in a tight location. The magnet was great for holding a screw where my hand couldn't reach.
William A Fischer III DDS
Reviewed in the United States on October 26, 2024
Very pleased with this purchase! Better than expected. I love quick change drill bits and these do not disappoint.
Scott L
Reviewed in the United States on October 15, 2024
Well made.
Lyle Swann
Reviewed in the United States on October 11, 2024
I don't know what it is these days but hardware seems to be getting softer. I'm always on the lookout for quality impact rated bits. This is a compact little plastic holder with different sizes of common bits. This includes an extension and a quick release. Actually the quick release might just be a magnet as I am able to pull the bits out without moving the ring on the extension.The bits are good quality though. I've used a couple of them dozens of times now and they are holding a clean edge and don't slip on the screws. Being impact rated I have no problem using them to drive 3" 8 gauge screws with an impact drill. I think a locking extension instead of a magnetic one would be the only improvement.
Recommended Products