Your cart is empty.
Your cart is empty.Product Description
POWER TOOL OUTLET
- Tool Outlet Connection: 2 or 3 prong plug.
- Max motor rating should not exceed 120V/15A 50/60Hz, 1875W.
VACUUM OUTLET
- Any standard shop type vacuum will run on the Ortis Auto switch.
- Vacuum motor HP should not exceed 1875W.
- Dust collector motor should be rated at 120V/15A and HP should not exceed 1875W.
- Power Feeders can also be controlled.
3 Power Tool Outlets
Addition of 3 tool outlets, then you can plug more than one tool. No need for extra extension socket, avoid messy cords and save time
Three Vacuum Run Modes
Three modes of operation: Auto, Off, On, allows use in either Auto or Manual mode when you want the vacuum and accessories to function independently. In ON/OFF MODE, the vacuum is turned on or off all time
Configurable Shutoff Delay Time
Automatically delays vacuum turn-off by an optional time 3s/7s/10s to continue clearing the remaining airborne debris after the tool has stopped, which reducing work area noise and improve work efficiency
Configurable Actuation Threshold
Configurable actuation threshold: 30W/60W, to prevent vacuum from running too long or being unable to shut off
THE NEW ORTIS AUTOSWITCH FEATURES
- New components
- A configurable actuation threshold (30W/60W)
- Supports a wide range of cutting tools from rotary handheld devices to large shop saws
- Optional 3 vacuum running modes: AUTO/OFF/ON
- Prevents circuit overload with 1s vacuum delay time
- Runs the vacuum only while you’re using your tool so you save time and electricity
- Automatically delays vacuum turn-off by a configurable time (3s/7s/10s) to continue to clear the air while the motor spins down
- Helps to comply with OSHA requirements for dust control
Ortis dust collector switch supports a wide range of cutting tools from rotary handheld devices to large shop saws such as Miter Saws, Table Saws, Power Sanders, Routers, Joiners, Planers etc. Max motor rating should not exceed 120V/15A 50/60Hz, 1875W
Denny
Reviewed in the United States on March 4, 2025
I have only had it for a day, but it’s been terrific. I wasn’t sure if it would handle my one and a half hp dust collector and my tablesaw or planer, but it has been great. No codes to mess with or anything else. Just plug it in and you’re good to go.
Recommended Products