Your cart is empty.
Your cart is empty.
Features:
Reverse polarity protection design:
This temperature meter is designed with reverse polarity protection, positive and negative reversed will not burn, but the screen display nothing
Specifications:
LED Display: red 3Bit
Length of sensor: 0.5 meter
Probe thread: M6
Dimension: 48 x 29 x 2 3 mm
Cutting size: 45.5 x 26 mm
Display size: 35 x 18 mm
Display color: red
Case color: black
Test temperature rang: -30-800 degree
Temperature accuracy : +/- 0.3 degree
Supply voltage: DC12 +/- 2V
Power supply interface: DC12 +/- 2V
Refresh rate: about 500ms/ time
Operating temperature: -20 degree to 50 degree
Resolution: less than 100 degree is 0.1 degree, more than 100 degree is 1 degree
Protection: reverse polarity protection
Self power consumption:
Package includes:
2 x Temperature meters
2 x K-type temperature probes
2 x Black red 2-wires
Note:
Manual measurement, please allow little size errors.
source
Reviewed in the United States on September 11, 2024
Work as intended . Not very accurate. Probe wire very short
Anon
Reviewed in the United States on June 6, 2024
Got these to install in a furnace I'm building. I wasn't paying attention to the fact that they require being wires to an external power source. It wasn't obvious from the description, either. There were no instructions with these, so I had to pull the specs up on the listing to find out they require a 12 volt power supply. Not really a problem, but I kinda hoped I could get away with putting in an on board battery. I'll think about updating the rating if I am super impressed with these once I install one.
Miss BlueBerry
Reviewed in Canada on October 25, 2024
This is a very cheap item, thermal couples of the same make model do not read the same switch them out still each meter reads the same regardless on the probe that I put on we cannot calibrate these display meters for the pro that were using your money and buy one at the little bit more expensive that you can calibrate is not worth your money
Miguel García
Reviewed in the United States on April 23, 2023
Ecxelente producto, cumplió lo que se esperaba y entregado a tiempo 👍
Randy Stahla
Reviewed in the United States on October 28, 2022
I use this all the time. It is very accurate & stable on a custom solar spectrometer I am building.I need this to monitor the temperature inside and outside of the spectrometer's enclosure.
R. Stever
Reviewed in the United States on September 10, 2021
I stripped the connector off the end of the probe only to discover a twisted pair of wires in both units. This will not read accurately. At this point I'm going to spend the extra money and goto digikey as none of these cheap Chinese meters are worth it.
Ken Bessler
Reviewed in the United States on November 13, 2021
I drive a emergency services communication van (ARES). I have a 200 ah LiFePo4 battery and the normal vehicle battery. I have a 250 amp transfer relay between the two.Most folks use a DC-DC charger to prevent overloading the alternator. I picked this item and put the sensor on my alternator.I figure monitoring directly for signs of stress is more important.It's a lot cheaper, too!
Recommended Products
$46.59
$ 23 .99 $23.99