Your cart is empty.
Your cart is empty. Product Description
This current detection sensor mainly detects and prevents equipment from overcurrent by setting the overcurrent point, so as not to cause equipment damage.
Specification:
Type: Current Detection Sensor
Current detection range: AC 0.3A-5A
Operating voltage: DC 5V / 12V / 24V(optional)
Working current: less than 10mA
Relay load: AC 250V 10A Max , DC 30V 10A Max.
The overcurrent signal setting is adjustable and the resolution is set to 0.3A.
Induction sensitivity: Potentiometer is adjustable.
Operating frequency range: 20Hz-400Hz
Output mode: switch signal output
Maximum detection wire diameter: 5.2mm
Mounting hole: hole diameter is 3mm, hole pitch is 52.5mm
Operating environment: -40℃ - 85℃
Board size: Approx.38 * 44mm / 1.5 * 1.7in
Board Description:
VCC: Operating voltage positive;
GND :Operating voltage negative;
NO: Normally open, the relay pulls before the NO and COM disconnect, short-circuit after the suction;
COM: common, relay common interface;
NC: Normally closed, the relay before the NC and COM short-circuit, after pull off;
Package includes:
2 x Current Detection Sensor(12)
1 x Screwdriver
Valkyrie Clark
Reviewed in Canada on April 14, 2024
Somewhat unclear description of specs left me with me with the understanding that VCC could be anything in between 5 and 24 volts. As I have determined, 12 vDC is required in order to power the relay's coil.Other than that, I have not as yet created the circuit I wish to control but see no reason at this time that I will have any difficulty in doing so - but you DO need some technical skill/understanding of what this circuit is and how it works.I may update this later.
Recommended Products
