Your cart is empty.
Your cart is empty.Product Description
Zenicham boat cover support pole,prevent water accumulation in boat cover. Adjustable height of the telescopic pole. Adapt to various boat types.
Adjustable Height
Our pontoon cover support pole is telescoping which can adjust to any custom height from 23" to 57" to fit your boat perfectly.
Extra Large Base
Our products feature an oversized 9" base that provides stable support without the hassle of straps.
Heavy Duty Aluminum Tube
It is made of aluminum alloy, which is stronger than ordinary plastic support rods. It can stably support the boat cover and is not easy to bend or break.
Prevents snow and rain from accumulating on your boat cover and causing damage or mold to your boat cover.
Sebastian Agustin Pigliacampo
Reviewed in the United States on February 26, 2025
Perfect
vcy
Reviewed in Canada on September 7, 2024
Work well with my boat
Scott L.
Reviewed in the United States on September 27, 2024
The bottom base is too light allowing the post to tip over while securing my boat cover. The top base is cheap plastic and already warped.
Scott MacPhee
Reviewed in Canada on September 17, 2024
It’s exactly what I ordered- thanks
william wilson
Reviewed in the United States on August 20, 2024
Supports my boat cover perfectly !
JP
Reviewed in the United States on July 30, 2024
The poles collapse they don’t stay up. They also fall apart. The glue or sticky tape that holds each section together came apart on both poles. This happened after using them two times, they didn’t even last a month.
Lynda Bouchard
Reviewed in Canada on July 30, 2024
Je les est mis en place mais aussi tôt qu’il y a de l eaux ils tombes alors il vas falloir que j installe des bande pour les tenir mais à pas cela ils sont bien fait
rodder98
Reviewed in the United States on July 14, 2024
The poles were adjustable, but they would never stay put when putting the boat cover on Seems like that if the base were heavier, they might. So, after I got the cover on, I crawled inside to position both poles underneath. Then, by crawling out, one of the poles would tip over. So, I had to crawl back inside again to stand a pole upright.They did kinda work, but are a pain in the a**.
SW
Reviewed in the United States on June 1, 2024
The main problems with these poles are that the pole comes out of the base every time you move the pole. We are going to glue them in somehow to correct this. The other problem is that they are so lightweight that they blow over if wind lifts the boat cover even a bit. We plan to try to weight the bottoms to make them more stable. We do like the rounded tops, which reduces chance of puncture of canvas cover.
Michel M
Reviewed in Canada on October 2, 2024
Je ne l’ai pas encore installé ce week-end j’entrepose mon ponton.
Paul R. Van Lith
Reviewed in the United States on October 19, 2024
Used for boat cover, it was very easy to use while the cover was on and near stretched, have no slack and should work very well.
Serge Tremblay
Reviewed in Canada on September 28, 2023
il manque lais deux pesse du bas
B
Reviewed in the United States on July 11, 2022
Struggling with covers that allow rain water to pond, is not much fun.The boat cover struts I purchased earlier did not meet my needs,either the pole is not strong enough to be crushed, or the base is too small and slips couldn't support my boat cover.Until I bought Zenicham boat hood support rods,the aluminum pole is very strong and has a good load bearing capacity,the large base of 9ins makes the pole very stable,very good design.After a rainy day, there is no more water on my boat cover.I highly recommend them.
Recommended Products