Shopping Cart

Your cart is empty.

Your cart is empty.

2 Pc Square 1/2' x 1/2' OD x 3/8' ID x 12' Inch Long Clear Extruded Acrylic Plexiglass Tube - 1/16' Wall

5.0 (4) Write Review
Free shipping on orders over $29.99

$13.49

$ 6 .99 $6.99

In Stock

About this item

  • Light weight Acrylic
  • UV Resistant
  • Extruded PMMA


You are buying 2 (TWO) NEW 1/2" SQUARE by 12" LONG TUBES of CLEAR EXTRUDED ACRYLIC. (One Half inch outside dimension by Twelve inch long) These tubes have a 1/16" thick wall which provides an outside dimension (OD) of 1/2" and an inside dimension (ID) of 3/8". The picture shows one square tube for representation of our product BUT you are buying and will receive TWO 1/2" OD x 3/8" ID x 12" square tubes. To assure that you get the finest quality, the protective sleeve is kept in place on the rods while being cut to protect the acrylic. All tubes have saw cut edges on both ends. Saw cutting can cause micro chips on the ends of the tube as seen in the pictures. Please allow a tolerance of +/- 1/16" on all piece lengths. PLEASE NOTE Width Tolerance is +/-0.015"


KK
Reviewed in the United States on June 21, 2023
This is a trial. Adhered with Araldite epoxy to fused glass pieces less than 12 total Sq inches for wall installation. Set for 72 hours. Time will tell...so far, so good!
Once a geek, ...
Reviewed in the United States on December 26, 2023
Good product. I use it as a channel for a drain hose siphon in my aquarium sump.
AVGamer
Reviewed in the United States on January 13, 2023
I am building a plexiglass case for a PC and charging ports these square tubes work great as supports for the box as well as channels for wires to be ran. Easy to cut file and sand to exact size. Made a second order right away as stock was running low. Please restock will definitely be ordering more.
Kay
Reviewed in the United States on June 12, 2020
I'm experimenting with using these tubes as hangers for fused glass wall hangings. They just came today so I can't tell you how they worked. I will drill hanging holes on one of the flat sides and glue the tube to the wall hanging. I'll use a small piece of the tube as a spacer toward the bottom of the hanging. If my glue holds, they will be perfect. So looking forward to having an affordable hanging option for my glass work.