Your cart is empty.
Your cart is empty.Product Description
Victor
Reviewed in the United States on September 4, 2024
I use it to control the flame level for my outdoor stove, works like a champ.
Frank Tufts
Reviewed in the United States on June 14, 2024
Knobs turn easy--full seal when closed.
Andrew Grossmann
Reviewed in the United States on March 29, 2024
Great for my rust tank drip line for irrigation. You can make micro adjustments and it’s durable
Earline Deason
Reviewed in the United States on March 17, 2024
One needle valve very difficult to turn. Other valve was ok.
Lawrence M. Elliott
Reviewed in the United States on February 7, 2024
Exactly what I needed for the air valve on my homemade cold smoke generator. Real sturdy and works great at a very reasonable price.
E_Dogg
Reviewed in the United States on October 4, 2024
I was surprised at the quality of these. They are solid, heavy, and work. One of the two had it's adjustment knob screwed a bit tight so I had to use pliers to loosen it. Once I did that, I worked perfectly. I use these as a secondary way to shutoff and control propane flow. For that, the work as expected.
Walter K.
Reviewed in Canada on July 3, 2023
Okay considering the price.
Bryan Barnard
Reviewed in the United States on September 12, 2022
These appear to be good quality, with a restricted flow potential (needle valves tend to be low-flow). Though the male 1/4" NPT pipe threads have in internal diameter of 5/16", the internal galley hole is only ~5/32" (~.164"). The knob goes from fully closed to fully open in ~1.25 rotations. The pitch on the threads is 1.25mm (or 4 peaks in 5mm).The "needle" has an angle of ~60º, and the "seat" contact point on the valve body is a sharp 90º corner, both of which will wear into each other. Time will tell how well this seals in the off-position under pressure... my application is not too critical in terms of leakage over time, as the application these will be used in will be limited duration, and when I'm done using the scrap furnace, the air & propane pressure on the system will be shut off elsewhere.The package includes two small packs of teflon tape and four silicone o-rings.Each valve weighs ~116g/4.1oz.Made in Communist China.
jack l.
Reviewed in Canada on June 30, 2022
Looks like high quality but it started to leak out of the valve after only a couple times of use. Junk !!!
Community Centre
Reviewed in Canada on March 7, 2022
Build quality is overall quite nice. Size is larger than you might think. Good for just air flow but seals do not work well enough for liquids. Drip leaks around the needle. Great price though for 2 pieces.
culinary lover
Reviewed in Canada on October 30, 2022
I made a camping stove using these needle valve and they are compatible to the thread of the pipe I used.
YOUSSEF Sukkar
Reviewed in Canada on December 23, 2021
it this is a good quality to make a dripping-oil for my lathe my stove or any other project
Recommended Products