Your cart is empty.
Your cart is empty.Phyllis Sink
Reviewed in the United States on September 24, 2024
The top piece of the main body was to large a diameter to allow it to seat. The cap was to tall from its interior contact point to the snap ring to allow the snap ring to lock in place. I wound up using most of the old parts along with some of the new to get a working servo. I would have returned it but did not have time.
Alex M.
Reviewed in the United States on August 18, 2024
The paint on the cap makes it difficult to install. Didn't really notice a difference in the 1-2 or the 3-4 but it works regardless.
Darryl Jackson
Reviewed in the United States on February 6, 2023
Fitted this when I did a complete rebuild of my 4L60E transmission.Transmission is coupled to a L98 gen 4 engine.Gear changes were harsh and banged a bit but after a few hundred miles settled down, but you can feel the gear changes, not smooth as an auto box should be.Then every second journey, or when on a highway I would have no 4th gear, just 1st, 2nd and 3rd.be cruising along and then the revs would go up and it would drop into 3rd gear.Removed the transmission and refitted the original servo assembly and transmission is as smooth as silk as it should be
Jared Collins
Reviewed in the United States on November 10, 2023
This thing rattled around in the process of being shipped loosely packaged. Horrible quality. I'm not even going to install this.
Jay
Reviewed in the United States on April 13, 2023
As I opened I seen it was defected but I stalled it anyway, first gear didn’t work so I put old one back in and it shifted normal save ur money and buy somewhere else but here
Paige Roe
Reviewed in the United States on April 13, 2023
After fighting to get the cap in because the paint made the tolerances to tight I found it was to thick for the snap ring to fit in behind it. After fighting to get it out (as u can see in the pic) i got a new o-ring and used the original cap on the new servo. Then test drove it and not a dang thing changed. What should have been a 30 minute job turned into a 3 hour waste of time and money.
Gail M Clark
Reviewed in the United States on December 8, 2022
It doesn’t fit a 4L60E the shaft was to long
Customer
Reviewed in the United States on October 28, 2022
On the factory cap you have spring after the c-clip is installed, this one cap is very tight and will not move
Recommended Products