Your cart is empty.
Your cart is empty.Tru Union Spring Check Valve Allows for easy repair and cleaning1-1/2"s x s, clear
Eugene T Miller
Reviewed in the United States on May 21, 2023
It fits on my pool. It works perfect.
Danny Musick
Reviewed in the United States on August 25, 2022
Works great, easy install. I've seen some reviews saying it only lasted them 6-12 mos. This product isn't made to last forever. There are rubber seals inside and they eventually go bad, then replace it, it won't be the last time. I'm in a desert state and they usually last me about 2 yrs or less. Make sure you get the correct size.
J Rod
Reviewed in the United States on January 2, 2021
Could not find this product at the pool store and was happy to find it on Amazon. Worked good for 6 months then stopped working. So now I must look around for another one that will last or buy another. Conflicted
Cave man
Reviewed in the United States on July 3, 2019
works like a charm and easy installation
Shannon L.
Reviewed in the United States on February 12, 2019
The rubber washer came off the valve at some point in the season. Worked well for awhile.
bladerunnerrocks
Reviewed in the United States on November 6, 2019
without this my little pump for a little pond just won't prime and start pump. however this doesn't last long. my first one lasted less than a year. I have looked for other options but have found none.
beinghelpul
Reviewed in the United States on August 25, 2018
After one year inner seal totally failed and nearly entered our piping. In the short time this summer our heater has already been damaged and white spa and steps were copper stained from this part failing to work properly. We moved to a variable speed pump now so hopefully this won't be a major factor (pump stays on). Our plumbing was designed for this valve so I had to drop in another without cutting out a lot of existing pipe.
Mark S.
Reviewed in the United States on September 17, 2017
Used these to keep water in suction lines and not to have to re-prime pump quite as often after long shut downs. Nice that they are clear and you can see any obstructions or debris sucked in. Easy to remove and clean with both sides union-ed. To make these work best, it helps if you have a riser coming out of them (going to the pump) of about 18" so there is some water back pressure to hold the values shut tightly.Here's how I piped them with a riser. The extra riser piping allow me to install some thermometers to monitor water temps.
Recommended Products
