Your cart is empty.
Your cart is empty.Product Description
Steve
Reviewed in the United States on May 17, 2022
Wobbly wiggle planks
Bell
Reviewed in the United States on October 18, 2019
The description in the website is very bendableBut it is not. once I bend to a not sharp angle it got brokenI’m really frustrated and I had to pay for shipping
Rodney Mallette
Reviewed in the United States on December 14, 2017
This is just a piece of 1/4" MDF that has been ripped every 3/16" to make it bendable. I expected it to be bendable plywood so I could make a prototype and maybe even a pattern. I do like using MDF and this was the worst case scenario because of those little rips.
Fosters
Reviewed in the United States on April 13, 2016
This is ok, however I think you are better off making your own if you have a circular saw or a table saw. It is not all that flexible, and like others said, the kerfs tend to break away (as they are entirely too thin/many (should be 12 per 90 degrees, distance between depending on radius) The kerfs being too small - too close to one another and the material is too thin - causes the kerfs to not be able to touch themselves at the tips - and thus put too much pressure on the outer layer when trying to bend it as much as it should bend with so many kerfs... or for tighter corners.My project was to bend it around a 23" diameter cylinder, for that it worked ok, and was basically drenched in glue to give it more strength. Your mileage may vary
WisFan
Reviewed in the United States on September 24, 2015
I bought this to fit around the bottom stair of our stairway which is curved at the base of the baluster. It worked fine in that application. I think we were at the limit of the radius this will fit as the first piece I placed around the curve ended up with a crease in it, probably from too sharp a bend. I was a little more careful when I wrapped the second attempt around it and it didn't crease. A little primer and paint and the step looks good.
raillink
Reviewed in the United States on July 11, 2013
I used this on an end of a model train layout to make a curved backdrop. It worked great and bent down to the required 10" radius I needed. I had no trouble cutting it. I used a jigsaw down the backside in one of the precut grooves. Perfect for what I needed.
skeeter stark
Reviewed in the United States on March 13, 2013
Bendy will tolerate a fairly tight radius. Used to form doors on curved front dresser. Accepts veneer very well. Before always had to cut reliefs with cabinet saw. Great product Will use again if need arrises
Patty
Reviewed in the United States on February 10, 2012
Tried to cut a 2" strip off of this thing and it disintegrated. All the little grooves went flying off. I can't imagine it getting any worse.
Recommended Products
$23.99
$ 11 .99 $11.99