Shopping Cart

Your cart is empty.

Your cart is empty.

12V Starter Solenoid Relay Switch Replacement 3 Terminals for Sten 435-700 Hus-qvarna 539101714 Trom-Betta 812-1221-211 854-1221-210 93265-9 93265WR 93265-WR

4.4 (8) Write Review
Free shipping on orders over $29.99

$9.99

$ 4 .99 $4.99

In Stock

About this item

  • Replaces Part Number: 435-700, 539101714, 812-1221-211, 93265-9, 93265WR, 854-1221-210, 8541221210
  • The case is made of premium plastic and the contact material is copper-cadmium, which ensures maximum durability.
  • The relay uses a small voltage from the key to the closed contact on the high current relay of the starter.
  • Solenoid is grounded through the base, when bottom mounting bracket, if necessary, there is a slot for mounting the strap
  • Compatible with Hus-qvarna Z CZ EZ iZ 4217 4219 4619 4818 4819 LZ RZ Series


Product Description

Starter Solenoid 435-700

This is the replacement part of Husqvarna, used for lawn tractors/mowers.

When the ignition switch is turned to the start position, the starter solenoid valve engages and distributes battery power to the engine starter.

The most common reason for replacing a solenoid is when the engine cannot be started or even turned over and the battery is dead.

12VDC with 3 Terminal/ Ground Base, Horizontal Mounting Bracket, 5 / 16-24 Motor Stud, 5 / 16-24 Battery Stud, 10-32 Switch Terminal

SPECIFICATION

Unit Type: Solenoid For Lawn Mower Tractors
Voltage: 12 Volts
Number of Terminals: 3
Threaded Top Terminals: 1/4"
Connected: 1/4 Male Spade Terminal
Continuous Amps: 200
Surge Amps: 300
Duty Cycle: Intermittent
Compatibility 539101714 starter or power trim solenoid for Hus-qvarna Most Riders and Zero Turn mowers

Replaces OEM Part Number:

BLU-EBIRD: 539101714
HUS-QVARNA: 539101714
DIX-ON: 539101714
YA-ZOO: 539101714
TROM-BETTA: 854-1221-210, 8541221210

Installation Tips:

To replace the starter solenoid, you will need the following tools: Socket wrench, Screwdriver (flathead or Phillips), Wire cutters or strippers, Electrical tape or wire connectors.

Here are the steps to replace the starter solenoid:

  • Disconnect the spark plug wire to prevent any accidental starting of the engine.
  • Locate the starter solenoid on your mower. It is typically located near the battery or starter motor.
  • Use a socket wrench to remove the nuts or bolts securing the solenoid to the mower. Keep track of these fasteners as you will need them for the replacement.
  • Once the solenoid is loose, disconnect the wires attached to it. Take note of which wire goes to which terminal on the solenoid.
  • Remove the old solenoid from the mower. Take the new solenoid and attach the wires to their respective terminals. You may need to use wire connectors or electrical tape to secure the connections.
  • Place the new solenoid in the same position as the old one and secure it with the nuts or bolts that you previously removed.
  • Double-check all the connections and ensure they are tight and secure. Reconnect the spark plug wire.
  • Test the mower by starting the engine to ensure the new solenoid is working properly.

Manny
Reviewed in the United States on February 12, 2025
Works well
Dave Liepold
Reviewed in the United States on January 8, 2025
Works great for a 2003 cudcadet 46” in lawn tractor.
Customer
Reviewed in the United States on September 3, 2024
It fit my snapper 30” lawn mower and it worked.Good product at a good price
Dennis
Reviewed in the United States on September 24, 2024
This item shipped quickly and arrived in new condition. Installed and operates as expected.Would purchase again.
Joe Smith
Reviewed in the United States on September 14, 2024
Was very pleased with starter solenoid was very easy to install and fixed start problems.
Reed family
Reviewed in the United States on June 10, 2024
It fit my Mzt61 Husqvarna with a 30 hp Briggs and Stratton engine. We are slowly and methodically replacing parts to eliminate why it sometimes refuses to start and sometimes dies on me while mowing and then won't restart. Fingers crossed this was it.
Kyle Sullivan
Reviewed in the United States on November 16, 2024
Garbage product. After installed, when attaching wires, the whole unit fell apart. Just garbage manufacturing and a waste of money.
Penner
Reviewed in the United States on October 26, 2024
Threads were slightly different on bolts from original, but no worries
Recommended Products
Caltric Starter with Relay Solenoid Compatible with John Deere X300 X300R X304 X305R X310 X320 X324

$63.00

$ 26 .99 $26.99

4.9
Select Option
Gekufa 33cc Recoil Pull Start Starter for Compatible with ATVs Pocket Dirt Bike 43cc 47cc 49cc 50cc Gas Scooters Pocket Bikes Mid-Bikes Mini-Choppers Small Quads with Claw Pawl Cog (Set of 2)

$12.99

$ 5 .99 $5.99

4.8
Select Option
Recoil Pull Starter Start fit for Predator 212cc 6.5HP Engine, for Honda GX160/GX200 Engine Go Kart Pit Bike Generator Lawn mower parts 28400-ZH8-013ZA

$11.99

$ 5 .99 $5.99

4.9
Select Option
MOTO1988 Starter Solenoid Relay for Yamaha YZF-R1 YFZ450 FJR1300 XV1900 5JW-81940-02-00

$10.99

$ 5 .99 $5.99

4.4
Select Option
AHL Starter Solenoid Relay Switch ATV Solenoid Part for Arctic Cat 1000 400 450 500 550 650 700# OEM 0445-058 0445-036 12 Volt 2-Terminal

$10.39

$ 4 .99 $4.99

4.9
Select Option
Universal Pull Starter Handle for Polaris, Ski Doo, Arctic Cat, Snowmobile (Black)

$7.79

$ 3 .99 $3.99

5.0
Select Option
MOTOKU Starter Solenoid Relay for DVX 400 LTZ 400 QuadSport Z 2003-2008

$8.99

$ 3 .99 $3.99

4.3
Select Option
Road Passion Starter Solenoid Relay Compatible with SS598T Motrocraft SW-1951-C SS4 Ford F150 F250 F350 F450 F550 SW1951 SW1951A SW1951B SW1951C E5TZ-11450-A E7TZ-11450-B E9TZ-11450-A SW1951

$11.89

$ 4 .99 $4.99

4.4
Select Option