Your cart is empty.
Your cart is empty.John
Reviewed in the United States on March 5, 2025
Only used once, so far, but seems to work as I had hoped it would. Price is for sure better than big box stores. Not a tool I will need everyday so nice to get it at a lower price.
Jose montalvo
Reviewed in the United States on January 25, 2025
It’s supposed to be flexible. It’s not flexible. If thing is hard like a rocket it doesn’t be.
PL
Reviewed in the United States on January 21, 2025
Strong, well made and engineered. Good value. Would buy again.
Deb
Reviewed in the United States on January 1, 2025
Very flexible and great quality. Has been very useful at my job in the plumbing,Heating ,hvac industry.
MARK A. DESALVO
Reviewed in the United States on September 26, 2024
Stronger than others I've had and covered shaft so you're not worried about grinding your hand holding on.
Ed
Reviewed in the United States on December 9, 2024
good product
John H
Reviewed in the United States on November 12, 2024
Extenstion tool for difficult angles and locations.Top quick release pushes forward to release. when you hold this area to stabilize bit as it spins, it slides forward dropping bit out of tool...if you use the plastic rod below quick release, it slides forward becoming stuck and preventing the quick release from moving. I had to cut 1/2" of the plastic off to be able to use the tool again.Out ide of these the tool holds on to bits and is easy to change. the end bit stays in drill. angle of bend, length are good.Would I recommend this to anyone? NO. I would recommend you get a tool that is designed better.
Mark Perrenoud
Reviewed in the United States on October 9, 2024
So, this was really good, for a time.It is flexible but sturdy.I have had right angle adapters break gears, but this doesn't have gears to break.However... the sleeve that covers it, designed for you to hold... while driving a screw in, it slide forward, got caught in the slip ring, and jammed the entire tool. It doesn't spin anymore. And the bit in it is stuck as the slip ring is stuck.All it needs is a little washer, built into the housing, to prevent the sleeve from sliding forward, that's it.Hopefully we see a version with that fixed.
Recommended Products