Your cart is empty.
Your cart is empty.
5PCS 1235M camshaft bearing set, a must have set for Chevy engine budget rebuild, cam bearings install.
Fits for Chevy Chevrolet GMC SBC Buick Pontiac Cadillac Checker 4.3L 4.6L 4.9L 5.0L 5.4L 5.7L 6.3L 6.6L 283 302 305 307 327 350 383 400 V8 Engine Block. Suitable for passenger car, light truck & heavy duty engine.
Cam Bearing Set.
john m isom
Reviewed in the United States on March 5, 2025
The oil holes are super small oil
mine
Reviewed in the United States on September 18, 2024
These bearings get pushed out when installing cam these are not within spec
Aliviana York 2.0
Reviewed in the United States on February 16, 2024
They fit SBC engines, they are not marked in the traditional sense but it's not hard to figure out where they go in the engine. #1- the bearing with two oil holes. #2&5- the bearings with a line stamped, #3&4- the unmarked bearings.They measure within usable range and have a good finish, these are not steel backed, probably aluminum.These are basic jobber bearings and I have no major complaints about them, but I don't think they are enough of a bargain to keep me from buying the CH-8 bearings that I've used for years, there's only a few of dollars difference.I Hope My Review And Pictures Were Helpful To You!!
Paulster2
Reviewed in the United States on February 12, 2024
These cam bearings are supposed to be for a Small Block Chevrolet (SBC). Any engine builder knows for the SBC, a set of cam bearings come in three different sizes. Most cam bearing manufacturers here in the States will mark the bearings accordingly, as well as give you an understanding (through a queue card) which bearing goes where. While inspecting these bearings, there are two which have markings on them (a small dash near the oil hole), but there is nothing telling you what the markings means. I thought maybe I was missing something, so double checked everything and yet there is nothing. Unfortunately because of this, these bearings are unusable to me.I can say it was nice that each bearing is individually wrapped in small zippered plastic bags. I didn't see any issues with the finish on them as they all were very clean and well matched as to surface finish.
Ryan
Reviewed in the United States on December 23, 2024
There is zero babbit on these. They are steel the whole way. Ate into my new cam and locked up in 10 seconds. Destroying my roller cam and sending metal into a fresh engine. Cost me over a grand to fix.
Recommended Products
