Your cart is empty.
Your cart is empty.High Speed Steel. Bottoming Style (Bottoming Taps have 1-2 threads of lead, for threading close to the bottom of a blind hole.) Ground Thread. Please note that not all bottoming taps are flattened at the end. Some manufacturers leave a point that you may have to grind off if going very close to the bottom of a hole.
Ricky W. Brame
Reviewed in the United States on May 15, 2015
Good product
Margaret
Reviewed in the United States on October 21, 2015
perfect
Wiley Ray Carter Jr.
Reviewed in the United States on April 21, 2015
Exactly what I needed and good quality
Barney Coopersmith
Reviewed in the United States on September 1, 2014
Worked as advertized
andrew mccain
Reviewed in the United States on August 21, 2014
Prompt delivery, worked great
TomK1
Reviewed in the United States on August 2, 2014
Sharp and accurate.I used these to re-tap some badly rusted holes in a Honda Odyssey chassis.The job was done in five minutes, it cut the threads quickly and it did an excellent job.
Josh
Reviewed in the United States on August 18, 2012
Bought this to clean up the threads on a Saiga 12 bolt carrier when I replaced the gas piston. The new piston wouldn't thread in all the way at first. Once I'd chased the threads with this tap the new piston was able to bottom out.
Recommended Products
