Your cart is empty.
Your cart is empty. Material: plastic and metal
Shape: Round
Resistance: 10K ohm
Resistance tolerance: + 5%
Independent linear accuracy: 0.25%
Power: 2W
Operating temperature range: +1°C+125°C
Storage temperature: -55°C - +125°C
Rotating life: 1000000
Load life: 1000 hours
Angle of Rotation : 3600±5°
Shaft diameter: 6.35mm/0.25in
Jeff W
Reviewed in the United States on September 25, 2024
This has only been in use for a few months, but linearity and build quality seem very good.Only downside - the pot itself turns smoothly, the supplied knob is stiff.
Darkoo
Reviewed in the United States on August 20, 2024
It's durable and good material . I used it in my car close to the engine and heat.
Chaomin Guan
Reviewed in the United States on May 29, 2024
No.2 contact is the one protruding the bottom cap, as long as we figure this out, getting the resistance we need is no brainer then. I needed two of those 1K pots as speed dials for my turntable, I bought 4 of them just in case. When they arrived, I pulled my DMM and peasured each one of them. ALL 4 gave me values that are legit and steady. I will be happily using them. Hope the same happens on the rest of you when you are reading this.
A Puzzled Tinkerer
Reviewed in the United States on May 28, 2024
Worked initially, but part way through the project I bought it for, something jammed inside, and then it quit working. Zero current, regardless of how you turn it.
texasconnie
Reviewed in the United States on December 9, 2024
This is a brand name bourns
Jeff
Reviewed in the United States on December 10, 2024
This potentiometer has the worst response ever. Small movements spike all sorts of resistances, it jumps all over the place. Certainly not something you want with a multi-turn pot. Additionally, if you put the count/position knob on you basically can't turn it without excessive force. Do not buy.
J Vigg
Reviewed in the United States on November 3, 2024
Standard 10Turn Pot with a Unique dial to indicate resistance. I did not find it all that useful tho
Matthew W Murphy
Reviewed in the United States on November 17, 2024
The media could not be loaded.
BAZ
Reviewed in the United Kingdom on June 22, 2021
The device had solder on the tags and had already been used. Before fitting it I tested its functionality. The wire wound coil is open circuit. Using a multimeter I tracked the fault to about 5K ohms along the track. Not happy, looking for a more reliable component supplier in the UK.
Recommended Products
