Your cart is empty.
Your cart is empty.Feature: Metal material,silver tone, flag shape ,L type, 6.3mm wire hole diameter.Clear insulated cover.
ralt33amzmusic
Reviewed in the United States on January 17, 2025
Not as low profile as I was hoping
ralt33amzmusic
Reviewed in the United States on January 17, 2025
Not as low profile as I was hoping
Sandy Retherford
Reviewed in the United States on October 16, 2024
Worked fine.
Sandy Retherford
Reviewed in the United States on October 16, 2024
Worked fine.
Jeff 2
Reviewed in the United States on January 12, 2024
well made
Jeff 2
Reviewed in the United States on January 12, 2024
well made
JW
Reviewed in the United States on June 29, 2021
Fit the push on spade terminal on lawn tractor ignition coil I have but the protective boot or cover is really not heavy duty and moves around when engine gets hot and allows coil to short outMay work good on simple electric connections in no hot application
JW
Reviewed in the United States on June 29, 2021
Fit the push on spade terminal on lawn tractor ignition coil I have but the protective boot or cover is really not heavy duty and moves around when engine gets hot and allows coil to short outMay work good on simple electric connections in no hot application
Ed W.
Reviewed in the United States on December 16, 2021
Every single one of these broke when being crimped. I tried, using several different crimpers, and every tab broke before they would even start curling over. Waste of money for sure
Ed W.
Reviewed in the United States on December 16, 2021
Every single one of these broke when being crimped. I tried, using several different crimpers, and every tab broke before they would even start curling over. Waste of money for sure
R. Dryden
Reviewed in the United States on April 19, 2019
A 1/4" spade connection that is configured in a 90 degree pattern is called a "flag connector". Normally the crimp is at the top so a normal crimping tool or die will not work. It takes a special flag connector die or tool to properly crimp it. This connector is what you need if you only want a few flag connectors in your project. The metal slip on part is separate from the soft plastic covering. The wire connection is made by bending down the two sets of tabs over the wire, so widely universal for various wire sizes. You can also solder the connection which make it rock solid. When the connection is all done, you slip the soft clear rubber sleeve over it -------------------------- excellent.
R. Dryden
Reviewed in the United States on April 19, 2019
A 1/4" spade connection that is configured in a 90 degree pattern is called a "flag connector". Normally the crimp is at the top so a normal crimping tool or die will not work. It takes a special flag connector die or tool to properly crimp it. This connector is what you need if you only want a few flag connectors in your project. The metal slip on part is separate from the soft plastic covering. The wire connection is made by bending down the two sets of tabs over the wire, so widely universal for various wire sizes. You can also solder the connection which make it rock solid. When the connection is all done, you slip the soft clear rubber sleeve over it -------------------------- excellent.
L. Blake
Reviewed in the United States on April 25, 2018
Not that special, but they work like they should.
L. Blake
Reviewed in the United States on April 25, 2018
Not that special, but they work like they should.
S. Quarders
Reviewed in the United States on April 21, 2018
what I needed!
S. Quarders
Reviewed in the United States on April 21, 2018
what I needed!
Recommended Products
