Your cart is empty.
Your cart is empty.Product Description
OE quality trim module boot
Replaces Sea-Doo part number 271000459
Clamp set
Includes 2 heavy duty VTS boot clamps.
The clamps are a little more difficult to install compared to the OEM clamps, but provide greater clamping surface area and increased strength.
Please hand tighten only, DO NOT use pliers.
Sam England
Reviewed in the United States on June 19, 2024
Bought this for my 99 Seadoo xp limited and it fit just right. Comes with clips for each side as well.
Nicole Lemieux
Reviewed in the United States on August 11, 2023
Fit perfectly. Rubber boot with clamps what else is there to say!
David S.
Reviewed in the United States on May 8, 2023
I bought two of these and they perfectly fit both my '96 XP and 97 XP seadoos!
Customer
Reviewed in the United States on July 22, 2022
Cheap, arrived quick, and install was easy with the help of a little grease to get it onto slide on. Make sure to clamp the rings down after the install. I opened the clamps up completely by just sliding them apart and then installed them after the boot was on.
john
Reviewed in the United States on June 25, 2022
Works great on my 96 seado xp 787
Adam smith
Reviewed in Canada on May 24, 2022
Fits perfectly , as described
Mason king
Reviewed in the United States on October 14, 2022
VTS hose was perfect on arrival and worked brilliantly as expected. Took less than 5 days to arrive in New Zealand from USA, exceeded all expectations.
Nathan
Reviewed in the United States on October 18, 2021
So far so good, received quickly. Rubber seems softer than oem, not sure yet if that will affect long term durability.
Travis
Reviewed in the United States on August 19, 2019
I bought a 1996 Sea-Doo XP from someone who had it in storage for 5 years. It was in good shape. However, I needed to replace the old grey fuel lines and clean the carburetors (Everyone with a Sea-Doo needs to replace those old lines and clean or rebuild carbs if they haven't already). Also, I made the mistake of not replacing this trim boot and when I trimmed down on the lake, the old boot tore, let water rush in through that trim rod hole and fried my VTS. So I had a hull half-full of water and ruined VTS. Ordered this new boot right away because of the plastic clamps (better for the longevity of the boot over metal clamps). Manually adjusted the trim to a good location by removing the VTS motor and spinning the gear, then re-attaching the motor.) First ride out and it works as expected. Didn't take on water. Also ordered an aftermarket VTS relay called "TheTrimFix" which I will update on after installation. It is supposed to be a much simpler fix for the crappy OEM VTS that always fails.
Recommended Products