Your cart is empty.
Your cart is empty.
Description:
- Needle Roller Thrust Bearings provide a high degree of stiffness within a minimum axial space. It has a smaller cross-section than a standard thrust bearing for use in restricted spaces.
- These bearings to accommodate heavy axial loads and peak loads due to small diameter deviation of the rollers within one assembly.
- AXK Thrust Bearings can be combined with washers in the TRA series in applications where adjacent components cannot serve as raceways.
- Made of hardened spring steel, both faces of the washers are polished and can be used as raceways.
- Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment, robotics, elevators, rolling mills, ship rudder shafts, and aggregate crushers, among others.
Specification:
- Bearing Model: NTA1625
- Bearing Washer Model: TRA1625
- Needle Roller Material: Chromium Steel (GCr15)
- Cage Material: ST13 Steel
- Bearing Washer Material: 65Mn Spring Steel
- Bore Diameter (d): 1"
- Outside Diameter (D): 1-9/16"
- Bearing Thickness (T1): 5/64"
- Washer Thickness (T2): 0.032"(Approx.)
- Dynamic Load Capacity (Cr): 13.8kN
- Static Load Capacity (Cor): 67.8kN
- Limiting Speed (Oil): 7000RPM
Package Contents:
- 2 x Bearings
- 4 x Bearing Washers
Robert C.
Reviewed in the United States on August 23, 2024
Put under steering assembly and the riding mower steers much better.
Dale Markle
Reviewed in the United States on August 2, 2024
They installed easily on. John Deere 212 tractor. They did make a noticeable improvement. Not like true power steering as is often stated.
Scott Ambrose
Reviewed in the United States on July 22, 2024
These glide very easily and I look forward to installing them on the front of our Craftsman lawn tractor to make it easier to steer.
M. Wilson
Reviewed in the United States on October 29, 2024
I bought an antique banker's chair that needed some work. The original bearings were missing so bought these to replace them and they work like a charm. Not enough time has passed since the restoration was completed for me to vouch for longevity, but the restored chair now swivels amazingly well. Time will tell, but even if they wear out quickly, I will buy them again. Meanwhile, happy spinning to me!
Sherman Tinney
Reviewed in the United States on October 23, 2024
Dislike did not help. Hard installation not worth the money.
Customer
Reviewed in the United States on August 28, 2023
Worked well as a thrust bearing in the storm lock on our hanger door.
GFenster
Reviewed in the United States on June 11, 2023
I used these for the upright steering spindles on on a John Deere 300 garden tractor. I used one of the included washers on the bottom. The upper surface was worn quite smooth so I omitted that washer. This gave me just enough room to install the original snap ring. While the effect is a little less than I anticipated, it Did make steering easier and smoother. No complaints considering cost.
AeroTec
Reviewed in the United States on October 13, 2022
Kidding aside, these bearings represent good value for money, with the understanding that they’re intended for low speed applications…to overcome thrust load resistance on initial rotation, although they can probably handle 75-150 RPMs continuously with proper lubrication.
Recommended Products
