Your cart is empty.
Your cart is empty.Product Description
Upgraded to pure copper motor
Compatible with all fans with the same 9"x9" blade
50 CFM | 2.0 Sones | Replacement within 3 years of damage.
Compatible with Nutone 763RL B, 763RLN B, 763RLL, 763RLN-R01
Also Compatible with 70CFM 769RL/769RF series fans.
Upgraded pure copper motor (the original was aluminum plated copper motor).
Life enhancement ↑ | Noise reduction ↓ | Quality improvement ↑ | Higher cost ↑
BillH
Reviewed in the United States on March 9, 2025
Fit like a glove. Easy install. Works much better than the old one.
Lane Hurraw
Reviewed in the United States on February 23, 2025
Worked well, fit right in! Now vibrates and makes excessive noise.
RKRUG
Reviewed in the United States on January 27, 2025
This replacement bath fan/light is as described, and the installation went as smoothly as others have described. The only cavaet I would add is that attaching the metal light assembly/white fixture cover is the last step before screwing in the bulb, and the provided vertical threaded bolt was too short to affix the wing nut, so I took down the unit, and swapped out the original (which was much longer and provided ample length).
Brittany
Reviewed in the United States on September 15, 2024
We needed to replace a super old fan in our 20 year old home but couldn’t find the replacement anywhere, until we found this one. Easy to install, sounds great. It’s been a few months and it still works perfect
Michael J. Wiesner
Reviewed in the United States on May 26, 2024
Since the fan in my bathroom light quit, I was considering replacing the whole thing. While researching, I discovered that there are not many fan/light combos made today that are going to fit in the hole in my bathroom ceiling. Then I found this. It is cheaper than a complete replacement and is all I needed. Once you get the cover off and the light bulb out, it's just one wingnut to get the light fixture out. Then one screw to get the fan out. I put the new one in, plugged everything back in and closed it up again. Works great and it is pretty quiet.
Eric
Reviewed in the United States on December 24, 2024
Perfect fit. Exact replacement of whole unit $143.00 this took 10 minutes to install, no tools needed. Fan works perfectly. If the model listed, definitely buy this and save some bucks. Not everything needs to be replaced, FIX IT.
Mckayla Savage
Reviewed in the United States on November 25, 2024
very easy to install, very quiet
Rick
Reviewed in the United States on October 15, 2024
This is a nice fan. It is actually quieter than the original. It is easy to install, but here is one tip:The vertical screw attached to the fan housing, which holds the reflector and socket in place, is shorter than the original, so you may have to take the one from the original and swap it out. In order to do this, you have to remove the motor- but that is easy too, as only two small nuts hold it in place. Remove the motor from the new unit, replace the vertical screw with the longer old one, and reattach the motor with the two small nuts. That's it. Just added 5 to 10 minutes to the install process. No big deal.
Recommended Products