Your cart is empty.
Your cart is empty.Product Description
FEATURES: Heavy Duty 10 Gauge power and speaker wire Inputs. Built-in crossover filters for easy tuning! Built-in variable crossover filters: HPF ( 10 – 700Hz ) and LPF ( 60 – 22 KHz ). It also includes Variable Gain Control. Level controls are not for adjusting volume. They adjust the amount of signal that is coming into the amplifier from your signal source.
POWER: This amplifier is designed to run your system with the power it needs to perform! 500 Watts maximum dynamic RMS power output on one channel. Its high efficiency rate of 85% provides more power with less battery consumption.
COMPACT DESIGN: Digital class D Brazilian technology allows this amplifier to have a small footprint by integrating a high-speed mosfet power supply with top of line transistors to ensure performance in a small heat sink without compromising performance. Dimensions: 3.93″ depth x 5.02″ width x 2″ height
Gemaine
Reviewed in the United States on August 16, 2024
I bought two amplifiers and a week later neither the midrange nor the bass amplifier works anymore. I do not recommend it.
Kindle Customer
Reviewed in the United States on July 14, 2024
Amp was exactly as described. Do not give it more than 15 volts, works as stated, very happy with the amp. Got it running 2 prv 8" speaker and wow they are loud!
Mr. J
Reviewed in the United States on June 29, 2024
The amp makes a loud "pop" when the car is turned on. I'm worried it will damage the sub that is attached. I'm going to return it for a more reputable manufacture.
Alex
Reviewed in the United States on January 27, 2024
i have install this small amp with a p1 300 watts sublet it work like for 10 minutes at 40% power. Then i have a cop car with a official telling me my neighbors have put a noise complaint
Grid Monkey
Reviewed in the United States on January 26, 2024
Even with the LPF and HPF all the way counter clockwise, meaning it should only pass audio between 10-60hz ( some bleed up and down obviously since its not a cut,) i was still hearing clean tone sweeps up to nearly 2000hz before it fell off. This would be fine if i wanted a full range amp, but i got it for both it's tiny size and supposed LPF to do some very tight bass. At 60hz on the LPF one should expect it to be gone by the time you hit about 125hz or so.i waited too long to get this installed and tested so now i have a great single channel amp for... something else.
Josue
Reviewed in the United States on April 18, 2024
Realice la instalación hoy 04/17/24 y funciona de maravilla buscaba algo compacto para mi honda ridgeline 2017 y es perfecta instalación sencilla con sus cables de fabrica y listo muy satisfecho esperemos que dure bastante tiempo buen bass 😁
Moros
Reviewed in the United States on April 16, 2024
This little amp as some power push 10 sub hard
Robyn Dressler
Reviewed in Canada on October 12, 2023
I was very restricted for space and this amp was a great solution. I give it only 4 stars for a few reasons. No installation documentation is supplied. The REM input should be between the POS and NEG connector. there is no +-marking for the high level speaker inputs. There is no gain control (volume) knob, only the input volume level which specifically states that it is not for volume. In any case, i set it to about 60% and that seems about right to drive a single 8” sub at 2 ohm for my setup - 2018 ford flex.
Customer
Reviewed in the United States on July 4, 2021
No issues so far!
Recommended Products
$599.99
$ 99 .00 $99.00
$69.00
$ 27 .99 $27.99
$81.78
$ 35 .99 $35.99