Your cart is empty.
Your cart is empty. Rail soft tape paste process (Compatible with machine maintenance and product use)
1.Preparation: Adhesive site to be clean, environment temperature better to 10 ~ 40 ℃. dark brown side Compatible with bonding, blue and green side is the working face.Remaining soft tape and glue should keep in dark place and moistureproof. To improve the bonding strength, metal rail surface roughness should take Ra12.5 ~ 25μm (finish 3 ~ 4); matching rail should be slightly wider than the soft rail, the surface roughness should take Ra0.8 ~ 1.6μm (Finish 7 to 8).
2.Cut: The width of the soft tape can be larger than 4 ~ 8mm of metal guide bonding surface,to avoid slip when you pate it.The length can larger than 40 ~ 80mm,so it's easy to tensioning the both side when you paste.
3.Cleaning: Before welding, it is necessary to remove the rust and impurities from the abrasive cloth, sandpaper or steel wire brush, then scrub clean and dry with acetone. If the old machine oil is serious, NaOH alkaline washing, and then scrub with acetone; conditional, but also on the metal rail surface Compatible with sandblasting treatment. At the same time with acetone to wipe the soft band of dark brown adhesive surface, dry spare.
4.Mixed glue:Glue must mixing according to you need,volume A /volume B = 1/1.2(or weight A/ weight B=1/1),then can use after uniform mixing.
The glue should be used in 45 minutes after mixed glue A and glue B.
Glue A and Glue B should use different splash bar.Can't use 1 same splash bar put in glue A cans and glue B cans.
5.Adhesive: Adhesive can be made with "Toothed Scraper" or 1mm thick glued wood. Glue can be applied to the metal longitudinal guide, horizontal coating on the soft belt, the coating should be uniform, the adhesive layer should not be too thin or too thick, with the amount of plastic can generally be controlled at about 700g / m2, Between 0.08 and 0.12 mm.
6.Paste: When the soft tape is just pasted on the metal rails,
