Your cart is empty.
Your cart is empty.5.0 out of 5 stars
- #327,956 in Tools & Home Improvement (See Top 100 in Tools & Home Improvement)
- #30 in Outdoor Landscaping Stone Masonry Forms
Stone Master Mold's manufactured stone veneer rubber mold in Fieldstone is ideal for making your own veneer stone for any indoor/outdoor project where stone cladding is needed. Fieldstone molds will create irregularly shaped fieldstones, also known as flagstones, that are all approximately 1-1.5" thick. Each mold is approximately 22.75" in length by 20.5" wide by 2" deep and makes approximately 2.9 square feet with a grout joint. Our molds require NO release agent. Available in 5 unique variations, with no stone repeats. Matching corners are also available. Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix: This is one suggestion for mixing the concrete for manufactured stone. There are many other instructions available online, including videos. BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete Maximizer, as it has lightweight aggregate, is high strength, and yields more product, but there are many kinds you can use. Follow the manufacturer’s instructions for mixing. If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc. A plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives… NO RELEASE AGENT NECESSARY. Vibrate molds to release air bubble. Cure in the molds for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stones at 70 degrees or greater until ready.
$43.99
$ 20 .99 $20.99
$67.95
$ 26 .99 $26.99