Your cart is empty.
Your cart is empty.Product Description
Our Skyflame Natural Gas fire pit hose kit will help you to make the process of making a DIY firepit more convenient, simple, safe, and efficient. Safety cutoff valve and key valve make sure it's safe.
With our key valve, you don't need to be so troublesome reaching the natural gas tank, just turn the key and enjoy a beautiful and warm fire pit.
Please Pay More Attention:
(A) . In order to use this product more safely, please close your natural gas tank firstly before you install this kit.
(B) . If the fire pit cannot light, check your igniter and sparker and try to replace one.
(C) . Make sure the gas valve is opened before start the lighter.
(D) . Safety warming: Close the gas if you do not want to use the fire pit for safety.
(E) . Don‘t place the hose in areas near high temperatures in case the hose be melted by high temperature and result in gas leakage.
Installation Methods About The Natural Gas Fire Pit Hose Kit:
- Connect one side of the 60” hose to your natural gas tank.
- Connect the two male adapters with the brass key valve and keep them tightly enough. Recommend to use sealing glue or sealing tape.
- Connect the 3/8” male adapter on the valve with the regulator hose and make sure it is fixed.
- Insert the brass key valve into your fire pit control panel and keep the valve chrome sleeve is exposed outside.
- Connect one side of the gas connection hose with another side of a 3/8” male flare adapter on the brass valve.
- Connect the other side of the 60 inches connection hose to the fire pit pan.
- Insert the key to the gas valve spindle and fix it.
- Please make sure all connections are holding tightly, then start your lighter and turn the gas valve till you saw the flame. ( Tips: You can use soap water to check if any gas leakage on connection points.)
60 inches Durable Rubber Extension Hose
- 1pcs 60" natural gas hose for connecting the Valve to Burner
- 1pcs 60" hose for connecting the Valve to NG Fuel Source.
100% Solid Brass Connecting Fittings
- 3/8" Male Pipe Thread x 3/8" Female Pipe Thread.
- Solid brass to provide a secure and sealed connection between applications and tank.
1/2-Inch Straight Quarter-Turn Shut-Off Valve Kit
The straight gas shut-off valve kit for NG Gas Fire Pits with Polished Chrome Flange, 3-inch Key and Two 3/8" Male Flared x 1/2 NPT Fittings for Your Convenience!
jpsandiego
Reviewed in the United States on January 15, 2023
The rubber lines are not heat resistant and melt. Installed under a metal fire pit floor to feed into a linear burner above the metal plate floor of the fire-pit. The lines melted from the heat going down from the burner and through the metal floor plate of the fire-pit (so there wasn't even that much heat). Luckily the lines melted themselves shut and stopped the gas flow so I was forced to investigate and found out what happened. Another likely scenario - gas would have kept coming from the hole melted by the heat and the whole thing would have blown up (what the call on the local TV news channel "a gas leak explosion destroys a local home"). I ended up with a $50 gas valve and key which I re-used with metal gas lines instead of the rubber ones that it came with. Notice in photo #2 how the heat also melted the rubber below the brass elbow connector to the linear burner. This product as configured is a major fire hazard if used in a fire-pit.
Recommended Products