Your cart is empty.
Your cart is empty.Product Description
Small Dual Stud Bus Bar 12V 250A Power Distribution Block.
Terminal Stud & Nut
Connections are solid! These greatly simplified and neatened up your install
- Stud Size: 5/16" (M8)
Tough Polycarbonate Cover
Reinforced cover attached with nylon nuts to prevent accidents and reduce the possibility of short circuits
Details
5/16" Stud Terminal
The 12v bus bar is M8 (5/16") studs screw, can allow max 250A current pass through the battery terminal block
Thickness
0.2 Inch
Protect Cover & Nuts
Each junction block will come with a cover and two nuts, which will shelter most exposed contact areas to reduce the risks of short circuit or touch
Connection
Universally used as a positive/negative battery terminal junction for wires in your automotive, boat, solar, campervan, rv, and more 12V- 48V DC.
WIRING OPERATION
-
4 x 5/16" Power Distribution Block Bus Bar
Mainly used for Car audio and Amps protection and in trucks, boat, RVs , marine and bus; also used in battery charges and DC audio system
Mikec
Reviewed in the United States on January 9, 2025
This will not last. It’s cheap metal and thin plastic.I do not recommend
One
Reviewed in the United States on September 11, 2024
I believe this power stud busbar is sturdy enough to be considered safe for my 24V PV system battery bank, even though the manufacturer advertises it for a 48V setup with 100A. I don't see any reason not to use it on a 24V 100Ah setup. I'm using 4AWG wire with 4-1/4 inch rings. When I ordered it, I chose an 8mm screw, but I should have ordered the 10mm, which would be more suitable for my setup. Nonetheless, I never pull more than 70A from my batteries. In my opinion, these dual busbars are perfect. They have a protected cap with plastic nuts that can be easily unscrewed without any tools. The busbar itself feels strong, and the bolts have a lock washer to secure the connection. I think it's a good choice.
Recommended Products