Your cart is empty.
Your cart is empty. Specification:
Type Name: ECU Control Module
Condition: Brand New and High Quality
Part Number: 39110-03420 3911003420
Compatibility:
Fits for KIA -MEG17.9.12.1
Package Includes:
1x Engine Computer Board ECU
Kindly Reminder :
1. About car anti-theft decoding matching:
If the ECU is installed, the car can not be started.Firstly check if the car is with anti-theft function or whether the key has a chip.
If your car is with anti-theft function, it is necessary to decode the match (with the decoder) successfully, then the car can start normally.
2. About installation:
Please find a professional auto repairman to install, and check the line voltage on the vehicle before installation. When installing, plug in the plug for test run, make sure there is no problem, and then fix the screw.
3. Before installation:
The battery is charged over 12V
The wiring harness is clean and in good condition
Any known defective parts have been replaced
All ground connections are in good condition and tightly secured
4. ECM Installation:
Disconnect the Negative terminal from the battery
Let the vehicle sit for Thirty (30) minutes unplugged
Install the new ECM (Be sure the connectors are inserted firmly)
Connect ground wires back to ECM (If applicable)
Reconnect the battery
Turn the key to the RUN position (do not start). At this point the "Check Engine is ON and means the ECM is working)
Leave in this position for 5 minutes
Turn Ignition to OFF position
Turn the ignition ON and start the car
5. They address all common ECU issues including:
● Electrical Problems
● Failure to Start
● Fault/Trouble Codes
● Intermittent Problems
● Loss of Power
● No Ignition Pulse
● No Injector Pulse
● Poor Fuel Economy
● Shifting Problems
▶Note:
before installing a new product, check and find out the cause of broken of the previous original computer board to avoid burning the computer board again with the same fault.
During installation, check whether the voltage and circuit are normal and whether the grounding is good.
The normal voltage of the computer board is 12V.
Do not install when the voltage is higher than the normal voltage, otherwise the computer board may be burned.
▶KESSOCCO has a professional technical team, that provides high-quality products and excellent after-sales service.
$28.99
$ 12 .99 $12.99