Your cart is empty.
Your cart is empty.REDLOONG Professional Brake Line Flaring Tool- 45/37 Degree Set - Single, Bubble, and Double Flares
Customer
Reviewed in the United States on January 23, 2025
I always dreaded flaring tubes with the cheap tools so I bought this one to flare some 37degree AN fittings. This tool created very clean double flares. Glad I bought it.
casey
Reviewed in the United States on January 14, 2025
I have a very similar tool I use at work and I thought this was the same one however this one seems to be a piece of junk. Will not even attempt steel lines and really really struggles with the nickel stuff.
rolemz
Reviewed in the United States on September 3, 2024
This things works great! I can't believe how little time it takes to do a complete brake line install on a car. It cut off so much time compared to the low dollar flaring tools, that I have more than enough time to complete my fuel lines and cooling system on my LS swap project. Had no issues and highly recommend this to anyone wanting to upgrade from the $30 flaring tools, not too mention looking for them little double flaring inserts that I would drop and never see again. Used this on stainless steel, and copper nickel 3/16" brake line.
Dude Bro
Reviewed in the United States on June 23, 2024
I installed all new brake lines in my classic car using nickel copper lines. This takes a little practice to get perfect fitting flares but once you figure it out it's a breeze. I started with steel lines and it was a bit harder to get perfect flares every time. Worth the money for sure. Beats the old school hand held flares for sure.
Joe
Reviewed in the United States on March 5, 2024
Just used the tool for a couple of flares and so far I’m happy with the quality. I did have to lube up the cam that presses the turret into the tube and any other parts that rub against each other.
Christopher Wallace
Reviewed in the United States on March 15, 2024
I had no issues with tubing sliding out of dies which was a plus.. dies are also labeled good.. it is a little rough on the moving parts but I'm sure oil and use will smooth it out.. did a 3/16 and 1/4 bubble flare and looked as good as anything that you would get from part's store.. also well labeled as far as the steps for making the flare.. don't think you'll get a better flare for the price.. I was surprised at how heavy it was..
Michael Kiser
Reviewed in the United States on October 15, 2024
This kit is good quality and worth the money for reworking the hydraulic system on my John Deere 317 restoration.Love it.
Customer
Reviewed in the United States on April 14, 2024
Unit works very well. A little bit bulky for tight areas.
Recommended Products
