Your cart is empty.
Your cart is empty.Thin M3 square nuts made from A2 Stainless Steel that conform to DIN 562.
Customer
Reviewed in the United States on September 9, 2024
They work for 3d printed r2d2!
K. Gross
Reviewed in the United States on March 6, 2024
They are perfectly sized for the MK 3/3S/3S+/4Worked on a few machines that needed parts, these were a match.
The Punch
Reviewed in the United States on November 18, 2024
Thickness varied a bit, but we’re between 2.1 and 2.35 mm, too thick for what I needed them for.
S.Sawa
Reviewed in the United States on September 13, 2023
My most used piece of hardware, perfect for embedding or slotting into 3D prints. Only wish I could buy in much larger quantities!!!
Mark
Reviewed in the United States on July 22, 2023
Nuts measured around 5.4 x 5.4 x 2.3mm. Nuts are too thick and does not fit Prusa's printed parts design.
ray c
Reviewed in the United States on June 9, 2023
works great with prusa and fits perfectly.
Thomas Teallow
Reviewed in the United States on May 5, 2023
These are not 1.8 mm wide. They are over 2.0 mm wide. Do not buy these to use with a Prusa. They will not fix.
Trailblazer
Reviewed in the United States on October 1, 2023
I used these nuts for creating a toy television show prop. They 3D printed pieces required use of squared nuts. These worked perfect for the purpose.
Recommended Products
