Your cart is empty.
Your cart is empty. Hydrogen Fuel Cell Regeneration Module Hydrogen-Oxyge Teaching Reversible Battery Physical Experimental Models
Specification:
Electrolytic area: 25*25mm
Power generation area: 25*25mm
Electrolysis voltage: 1.5V-3.0V
Generation voltage: 0.5V-0.9V
Hydrogen production rate: 8ml (1A)
Oxygen production rate: 4ml (1A)
Steps for using electrolyzed water:
1. Fill both sides of the battery with water, and the water level should reach the bottom of the upper air outlet
2. Plug the lower air outlet on both sides
3. Connect the two upper outlets to the gas collection device with a conduit
4. Turn on the DC power supply and start electrolyzing hydrogen and oxygen
Steps for generating electricity:
1. Plug both lower outlets
2. Connect the upper air outlet on both sides to the gas device with a conduit
3. Pass the positive and negative terminals of the battery into O2 and H2 respectively
4. Open the lower air outlet before plugging it to exhaust the air in the battery
5. Turn on the load
Note: production batches with different colors are randomly shipped!
$31.00
$ 14 .99 $14.99
$205.00
$ 81 .99 $81.99