Your cart is empty.
Your cart is empty.
E-Z Lok manufactures threaded inserts for metal, plastic, and wood. The company is headquartered in Gardena, CA.
RMS1
Reviewed in the United States on February 24, 2024
It makes installation a snap. I even use it to install stainless steel threads in 3d printed plastic parts.
EJH
Reviewed in the United States on November 17, 2024
Works well.
JCC
Reviewed in the United States on October 21, 2024
I needed this kit to repair a damaged thread in an old carburetor, it fixed it as good as new.
BE from ME
Reviewed in the United States on April 24, 2024
I like that this kit had everything needed to do the job. I used it for the muffler bolts on a Jonsered CS 2152 chainsaw. It was the first time I tried a threaded insert and it worked great. It was a little pricy for what you get but cheaper than bringing the saw in for service.
JAP
Reviewed in the United States on May 14, 2023
I used the kit to repair a stripped out thread on aluminum block. I was able to salvage the situation and assemble what I was working on.
Bruce B.
Reviewed in the United States on December 17, 2023
The tools were usable but the inserts were the incorrect diameter. I purchased some inserts from another company and used these tools to install them.
Charlemagne
Reviewed in the United States on November 25, 2023
I bought this to make a 10 minute repair on my Husqvarna chainsaw where the muffler bolts to the block. The tap or something is wrong and my bolts won’t thread in. My $500 saw is now ruined because of this product. I want compensation!! We’ve gotten too used to accepting this low level of quality and now companies do not care about customers anymore. I’m screwed. I heat with wood and have no money for a new saw. I’m devastated.
Bob Villa
Reviewed in the United States on September 30, 2022
Ordered the 10-32 set to repair a carburetor screw hole that had been stripped. Worked well on the aluminum body of the carb. It comes with good basic instructions if you have never used a helical insert.The only thing you'll need besides this kit are a drill, tap handle, and a tiny allen key to set the depth collar on the helical insert tool.Good set for the money.
Gordon S.
Reviewed in Canada on December 10, 2020
Like another reviewer, I found that the STI tap provided in the kit produced threads that caused a 10-32 screw to bind. I checked and found that it didn't have 32 Threads per Inch. I couldn't figure out the pitch. But, I contacted the EZ-Lok customer service from their website. They apologized for the problem and sent me a replacement tap that was 32 TPI. It worked properly. It was a different brand of tap, so maybe all of their 10-32 kits have the wrong tap. Moral of the story with any of these kits: check the tap pitch against the screw before using it. And, test it on some scrap first. Otherwise, E-Z Lok is a reputable company.
Recommended Products
$12.39
$ 5 .99 $5.99