Your cart is empty.
Your cart is empty.E-Z LOK threaded inserts for metal provide an easy to use solution for repairing or reinforcing threaded holes in metal. Ideal for use in metals like aluminum and cast iron, E-Z LOK threaded inserts are screw machined out of solid steel for greater strength and superior pull out resistance. Standard external threads permit the use of standard drills and taps for installation. Once the hole is prepared, E-Z LOKs are threaded into the hole like an ordinary fastener using a screwdriver, bolt and jam nut, or optional E-Z LOK drive tool. E-Z LOKs are self locking and will not back out or vibrate loose. A preapplied adhesive activates upon installation and bonds to virtually all metals. Fastener-ready in minutes, the adhesive seals against liquids and gases to pressures of 6,000 psi. when fully cured (72 hours).
Tommy Ross
Reviewed in the United States on February 12, 2025
ok
Kindle Customer
Reviewed in the United States on October 12, 2024
These are pretty standard parts, but the seller helped me tremendously by shipping quickly, used FedEx and they arrived well before expected date! Will readily purchase from seller again!!!!
Donald Stenersen
Reviewed in the United States on September 6, 2023
Installation was a bit difficult due to location.
Josh J
Reviewed in the United States on October 27, 2023
These hold up well when properly installed. I remove the red locking agent and apply JB Weld onto the threads, they don't come out......
Andy S.
Reviewed in the United States on April 17, 2021
Amazing product. I accidentally stripped the threads in an aluminum block on my subaru. Installed these and it was able to hold even at 39 foot pounds
DmOcRsI
Reviewed in the United States on August 19, 2020
Pretty easy... but make sure you have the right size tap, the EZ-LOK I used requires a 9/16-12 tap, but my set only goes up to 1/2".Once I got it in, I ended up nudging it just a touch deeper to get it flush. It takes 72-Hours to fully-cure so I am not taking any chances.
Raymond L.
Reviewed in Canada on June 4, 2020
Product was used to repairs threads holding stem on casters on high end Italian office chair. Very easy to use. Drill, tap and install.
Greg V.
Reviewed in the United States on October 7, 2019
I made a wooden shift knob for my car and needed to mount it to a standard shifter. This worked great. I ended up using epoxy to lock in the insert as the pre applied threadlocker does not work on wood. I kind of expected that would be the case.
Roy
Reviewed in Canada on April 29, 2019
As advertized
Jordan N.
Reviewed in the United States on September 3, 2017
Worked excellent. Need to buy the driver tool to properly use this item but it fixed my b series timing belt motor mount.
Recommended Products
