Your cart is empty.
Your cart is empty.GENUINE NEW OEM 82620-3E030 Fusible Block Link Fuse for Highlander Vehicles
Tyler B. Gleditsch
Reviewed in the United States on January 4, 2025
Fuse was an exact OEM replacement. To remove the old fuse you need to take apart the fuse box and unscrew the fuse from the bottom. It's like taking apart a brain puzzle, good luck.First remove the battery, then the air box and the ECU. Disconnect the brake fluid level sensor and remove the mounting plate. Move the brake reservoir to the top of the air duct, It should be secure there.Remove the top of the fuse box. The fuse box electrical connectors require disconnecting, then you slide up and out the small section below the single 10mm nut, a small clip is holding it in on the top. You will need to unbolt the fuse box from the body at this point. After that, the box needs to be split from the tabs all the way around the outside. The next step is to push down and release the fuse section downward through the bottom of the box cover. If you look closely at the top section you can determine where the internal clips are located. The internal clips are mostly in the corners and quite a few near the drivers side. Once the fuse section is released from the cover and pulled through the bottom, Then you need to release the gray fuse block up and out via a clip on each end. After the gray fuse block is pulled up, you don't need to disconnect the bottom connectors if you dont want. With the gray block out, it will expose a white plastic cover below the box. There are two small tabs on the white plastic cover. These tabs need to be released in order to pull down the cover. There are two 10 mm / Phillips bolts that wire the fuse in place with the alternator. Once you have the fuse unscrewed, on top There is a single clip on one side of the fuse. Release the clip while you pull it out with pliers. Congratulations. You are now a certified auto surgeon.
Recommended Products
$22.35
$ 11 .99 $11.99
$10.01
$ 4 .99 $4.99
$19.62
$ 8 .99 $8.99