Your cart is empty.
Your cart is empty.These heater hose ends are designed to hold up to any plumbing task you have. They are made from high quality aluminum to ensure they won't rust or corrode. They are available in clear anodized and black finish and in a variety of sizes to suit your application.
Happystains
Reviewed in the United States on August 21, 2024
It is what it is. A specialized heater hose adapter to bypass a poorly designed heater tube assembly. Still probably not worth the close to $40 spent. Would have loved this in black but could not see spending another $10-$15 on a small piece of metal just to have it not shiny. Have yet to get this installed but if I have any issues, or product turns out to be a POS, I will update the review.
mark barlow
Reviewed in the United States on June 20, 2022
i ordered two of these trying to route both of the heater hoses behind the alternator on my small block chevy. i was trying to make the heater hoses less visible. one worked out really well in the place that its intended to go but the place in coming off of the water pump will not spin around to be able to screw it in. this is the place where the straight connector goes.i thought it would work but it did not
Customer
Reviewed in Canada on May 3, 2022
I used this with an Edelbrock manifold and had to use a 1/2 to 1/2 coupling as the 90on the fitting would contact the manifold when turned. Could not tighten.
Mr. H
Reviewed in the United States on October 12, 2022
Expensive but works & looks great.
Big City Bob
Reviewed in the United States on September 19, 2021
I used this fitting on my Chevrolet 396 Big Block with an Edelbrock RPM Air Gap intake manifold. Works as advertised. Fits factory threaded hole and is way better than the factory fitting that causes your heater hose to kink.
tom
Reviewed in the United States on May 6, 2021
Was the perfect fit for my 460 performer RPM manifold heater hose.
Greg T Roberts
Reviewed in the United States on November 13, 2021
Looks nice, fit well, allowed me to have a cleaner heater hose routing for my 68 corvette with small block and Edelbrock performer intake manifold.
Ed
Reviewed in the United States on October 22, 2021
The part was 1/4 inch to long on threads, had to trim. But is working fine
daniel
Reviewed in Canada on August 13, 2020
Perfect
Joe D.
Reviewed in the United States on October 15, 2020
Cleaned up engine bay just a little bit more, i used liquid teflon (thread sealant) vs tape so you can stop exactly where you want it with no leaks as top does not rotate.
Dusty
Reviewed in Canada on October 12, 2019
Perfect fit
Recommended Products
