Your cart is empty.
Your cart is empty. Car Front Headlight Lens Cover Auto Case Headlamp Glass Lampshade
Features:
- New and High Quality
-Made of high quality polycarbonate
-With protective UV coating to prevent yellowing or fading
-Transparent shell, does not affect luminescence. -Easy to remove and install
-Note: Before purchasing, please make sure this item fits your vehicle.
Methods for disassembling and assembling lampshades
1. Remove the entire headlight (some models require removal of the grille and bumper). If the headlight cannot be removed, it is not recommended to do it yourself
2. Check the area around the headlights to see if there are screws fixed. If there are, remove the screws first
3. Prepare a hot air gun (high-power hair dryer is also acceptable), a flat screwdriver, and aim the gun at the pointed corner of the headlight to blow
4. Pay attention to the distance between the air vents, control the time, and avoid blowing the lamp body. After 3-5 minutes of slight heat, quickly remove it with force
5. Use a flat screwdriver to press against it, pry open a hole, and continue to blow soft sealant along the edge with a hot air gun
6. Blow and peel open at the same time, and it will all peel open in a short while. (The lampshade and interior decorative frame are connected together)
7. Use a screwdriver to clean the old glue, and clean it thoroughly. Remove the snake glue and tear off the oil paper
8. Remove the decorative silver frame from the old lampshade (don't forget) and install it onto the new lampshade
9. The hot air gun evenly blows heat to soften the new snake glue, blowing a few more times to slow down the blowing speed. Softening snake glue
10. Observe the specific location of the glue on the old lampshade, and make a rough mark on the same position of the new lampshade
11. Apply force evenly to close the old lampshade, making sure it is evenly pressed all around, all corners, and the depth of pressure should
