Your cart is empty.
Your cart is empty.
Super Precision Bore Gauge Deep cylinder bore gageing to a depth of 10" affords the user the ability to measure out-of-round conditions and tapers of cylinders without the necessity of removing pistons - critical wear area of the cylinder can be reached with this gauge. Super precision up to 0.0005" at range from 1.4" to 6"
Features:
- Super Precision Deep Bore Gauge
- Measures bore to 10" deep, Range 1.4" to 6" diameter
- 0.0005" Crisp Precision Graduations
- Includes gage and interchangeable contact points
- Carbide tip on measuring plunger
- Dial indicator contains jeweled bearings, ABS storage case included
R. Legato
Reviewed in the United States on August 25, 2024
But not a brand that my employer would accept for quality control.
Placeholder
Reviewed in the United States on September 12, 2021
I am using this on a engine block work's good.
Brian K. Hockenberry
Reviewed in the United States on May 5, 2021
Everything looks good. Seems to work good. Haven't done much with it yet though
OLD man
Reviewed in the United States on June 1, 2020
Solid and well made, shall check of precision of dial indicator and unit built after a bit of use. Unit checked good at this point. Very happy to have picked this outfits product; there are so many low cost item that looks the same, but does not have same spec as this one.
will harf
Reviewed in the United States on March 12, 2020
What a good deal,very affordable! get one now Before they appreciate in value!
EB
Reviewed in the United States on February 16, 2020
I was a little disappointed with the accuracy of this tool. I didn’t expect a lot but with the 3.6 extension installed it’s .06-.07 off. Easy enough to do the math to make it work, but wasn’t expecting it to be that much off. It’s not within .005 with the extensions for sure. Still usable for measuring engine cylinders
dw
Reviewed in the United States on June 26, 2018
Great tool for rebuilding an engine. Proved to be very accurate (against a known reference). Occasionally it slips a littte after some time, so recheck against your caliper now and then just to be sure.
Customer
Reviewed in the United States on March 26, 2018
Setup of the gauge seems to require more steps than expected, and a small collection of spacers must be used for certain bore sizes. Easy to misplace these spacers.The dial indicator was fine, however the action of the measurement head seemed a little coarse compared to Starret.Also found tool has a plastic guard over the dial indicator head that obstructs access to the dial lock and the guard gets in the way.
Recommended Products
$73.50
$ 28 .99 $28.99