Your cart is empty.
Your cart is empty.Cutting edge geometry designed to reduce chatter and harmonics. Six flutes allow higher feed rates and provide longer tool life due to distributing the cutting load over a greater number of teeth. The 1/4 diamer is solid carbide. The larger diameters are brazed construction.
Kirkyd123
Reviewed in the United States on July 26, 2020
I’m very pleased with it. I countersunk 64 holes to max depth in 304 stainless using a few drops of Tap Magic XL. It cut the last countersink just as well as the first. Cutting oil is a must on stainless.
Kirkyd123
Reviewed in the United States on July 26, 2020
I’m very pleased with it. I countersunk 64 holes to max depth in 304 stainless using a few drops of Tap Magic XL. It cut the last countersink just as well as the first. Cutting oil is a must on stainless.
Cindy Lende
Reviewed in the United States on November 20, 2019
Counter sinks 16ga stainless no problem.
Cindy Lende
Reviewed in the United States on November 20, 2019
Counter sinks 16ga stainless no problem.
Casey Johnson
Reviewed in the United States on September 7, 2017
Great cutter. Love the long shank for getting in deeper recesses. As advertised!
Casey Johnson
Reviewed in the United States on September 7, 2017
Great cutter. Love the long shank for getting in deeper recesses. As advertised!
Brute force fab
Reviewed in the United States on February 15, 2017
Nice quality counter sink
Brute force fab
Reviewed in the United States on February 15, 2017
Nice quality counter sink
Moisey Fokina
Reviewed in the United States on December 28, 2016
Great countersink, lasts a long time. Three things I disliked about it1. Loud because it will chatter unless you put it in a drill press or lathe.2. The slivers it produces are like needles! Do not sweep of with your hands. I would suggest to have a vacuum ready to clean up chips.3. Will plug up when working on aluminum. Seems like a little iso or denatured alcohol helps keep it clean though.Otherwise a great countersink.
Moisey Fokina
Reviewed in the United States on December 28, 2016
Great countersink, lasts a long time. Three things I disliked about it1. Loud because it will chatter unless you put it in a drill press or lathe.2. The slivers it produces are like needles! Do not sweep of with your hands. I would suggest to have a vacuum ready to clean up chips.3. Will plug up when working on aluminum. Seems like a little iso or denatured alcohol helps keep it clean though.Otherwise a great countersink.
Recommended Products
$12.26
$ 5 .99 $5.99