Your cart is empty.
Your cart is empty.An additive for paints and stains for slip resistance, fine texturing, and gloss reduction. Stirs in easily to most any coating and has little effect on the viscosity of the coating. It has low density which allows it to stay well suspended even in thin b
Cody Stooksberry
Reviewed in the United States on January 30, 2025
The product works as intended. I wish there were a bit more for the money but overall it is a good product. Easy to apply and the durability has been good so far, we installed it 6 months ago.
Deepsea driller
Reviewed in the United States on August 23, 2024
Great price for this nonskid that worked very good with Total topside paint
Curtis
Reviewed in the United States on February 6, 2024
Added this to the paint and now my porch steps aren’t slippery when wet.
TKC
Reviewed in the United States on July 16, 2019
I was skeptical about how these beads would work, but they do. the floor feels great. Not too rough at all, but I don't worry about slipping. An epoxy floor without these beads would be a slip & fall nightmare.
Mike
Reviewed in the United States on June 21, 2018
I added this to my final top coat of PPG Amerishield VOC 2 part polyurethane, per instructions. 1 bottle to 1 gallon per the instructions. The product stayed suspended in the poly after initial mixing. Once the poly cured it revealed a nice soft finish. The granules didn’t sink in the poly, which was applied at ~5mils thick. When you walk barefoot on it, it isn’t sharp under foot and with shoes on it gives a nice planted feel. Very similar to boat shoes & non skid marine coatings.I was a little worried about it breaking up the high gloss finish, but after everything cured the high gloss was back.When mixing it into your paint/poly of choice, introduce it like your adding flour to a mixing bowl. Adding a little at a time while power mixing and you’ll be okay.
TERADON W COLLINS
Reviewed in the United States on December 7, 2018
Product is good, but it's dropped shipped from Lowes and marked up to double their price. I should have looked around more.
Happy Shopper
Reviewed in the United States on August 1, 2015
Sharkgrip works as advertised. I had a stamped concrete overlay put over my existing sidewalk. It was so slippery I was sorry I had it done even though it made a world of difference in my homes appearance. My husband added the shark grip according to the instructions to the sealer and now its like walking on invisible sandpaper. Fantastic. Now I am thinking of doing my back patio with a design without worrying some one will slip and fall.
MrN
Reviewed in the United States on January 1, 2014
My wife and i were about ready to tear up our new stamped concrete patio because is was so slick it was dangerous when wet. Researched products to add a textured surface and found this product. I liked the fact that it suspended in the sealer material and did not sink to the bottom before drying. I used a cheap pump sprayer to apply it by pouring in the grip material after putting in the sealer. I made sure to stir Very well and then sprayed on as fast as i could to prevent the material from settling. Once dried it left a slight textured surface that is now slip proof but feels fine in bare feet. Texture also slightly changes the sheen of the concrete but not enough to create a problem. Now that we have this solution we may put stamped concrete in the backyard also.
Recommended Products
