Your cart is empty.
Your cart is empty. Package including
2pcs LED flasher Relay
6pcs blue wire connector
Features:
✪Suitable for flasher light during car turning；
✪High sensitive and stable electronic timing；
✪Wide operating voltage, temperature range and long life
✪Standard terminals, usage and Replacement easily；
✪With ticking sound when it works, no buzzing
Technical Data:
Life Time:400 hours continuous use.
Rated Voltage:12VDC
Operating Voltage:8VDC ~ 12.8VDC
Switch Load: 0.1W ~ 150W (0.02A ~ 20A)
Max Power:150W
Flashing Frequency:55 ~ 93 times per minute
Operating Temperature:-40°C ~ +80°C
Getvicious
Reviewed in the United States on September 29, 2024
My son ordered these for his Buell. They work great on his bike.
Colin isabelle
Reviewed in France on September 2, 2024
Top rapport qualité prixRéglage de la vitesse de clignotement, c est topFonctionne même avec clignotants led très basse consommation. Sensible au court-circuit, prévoir un fusible.Je recommandeJe recommande.
Maria
Reviewed in the United States on May 9, 2024
Plug and play. Tried another product that said it was supposed to work, but just got solid lights when activating the turn signals. This one works as described and the adjustable rate works as well.Update: Not sure when it quit on me, but couldn't have had more than 4 hours of ride time. I'll update after I use the 2nd one a bit, but it did work when plugged it in.Update #2: 2nd one quit on me. Worked when I first plugged it in, then during my ride, quit working. This time only on the road for less than an hour.Update #3: 3 down, 1 to go. They work when I first plug them in, but this 3rd one quit working while riding, too. Stars dropping like flies.
Venom
Reviewed in the United States on February 4, 2024
I bought these for a project where I needed to have Flashing LED lights. They hook up very easily and work great. You can see the wiring diagram for them in the sellers photos.
jack smith
Reviewed in the United Kingdom on November 23, 2024
Tobimobi
Reviewed in Germany on November 23, 2024
Die Relais sind am Mover vom Wohnwagen angeschlossen, da ich Abends ab und zu an der Straße "rummovern" muß und etwas Beleuchtung da nicht schadet.Bei einem Bekannten haben wir das defekte Blinkrelais an einem alten Volvo ersetzt, das funktioniert ebenfalls so wie es soll.
Thomas Hansen
Reviewed in the United States on April 13, 2024
This was a great replacement flasher for my Evolution LSV golf cart vs. time it would take and cost of a flasher from the dealer. It works perfect. The bracket wasn't present so I had to make a bracket and attached the flasher with a cable tie to the bracket.
Ray
Reviewed in the United Kingdom on August 22, 2023
Does what it supposed to do.
Catherine H. Stringer
Reviewed in the United States on November 15, 2023
Converted to LED turn signals on 1975 Corvette. Tried a couple of others before this with no success. This one works really well and the speed control is great. However, the wiring diagram shown is incorrect. There is a negative, a feed from the turn signal and a feed to the lamp. There is no permanent positive connection required. Just add a ground and make sure the other two wired are the correct way round. If it doesn’t work, just swap them.
Colin
Reviewed in the United States on April 28, 2023
great value and works excellent for motorcycle converted to LED blinkers.If I am honest I ordered the wrong flashers and when I plugged them in they did not work. I had to switch the + and - wires and these are awesome. blinking speed is fully adjustable and seem to be handling extra load from the LED blinkers just fine. also with the extra wire I added I can locate this flasher pretty much anywhere on the bike.
Michael P Vanwinkle
Reviewed in the United States on July 26, 2022
I have a 1991 GMC Sierra truck where I added LED bulbs. Turn signals were then too fast. Existing Flasher is shown in the first picture. Note that Battery + is the right hand terminal. Gebildet LED Flasher won't work out of the box due to Battery + being on the left terminal. I modified the flasher by running crossing jumpers from the internal terminals to the circuit board. Wasn't easy but the LED Flasher works fine now for my truck. Your only other alternative would be to make external jumpers and cross them that way. I chose the internal mod to keep everything looking factory. I like the fact that you can vary the turn signal speed with this flasher.
francisco pino cid
Reviewed in Spain on January 28, 2022
Han funcionado pero al final solo he usado dos porque funcionaba muy rápido con los 4 son grandes y algo abultados serán todos así
Lawrence Sprout ( Lonnie )
Reviewed in the United States on April 9, 2021
It said that it would work on both of my motorcycles. It worked on one but not the other.
Recommended Products
